Regulator for Generac Propane Generator

Question

Question:

I want to hook up a Generac 22 kw generator to 2 or more 100 LB propane tanks. The tanks will be about 50foot from the generator. According to the book I will need to supply 355,000 BTU/h and 12inch WC . Can you tell me what fittings and regulators I would need.

asked by: Tim C

0

Expert Reply:

12 inch water column is standard for LP low pressure propane so for a regulator the # 108220 would work great as it is an LP regulator capable of 400,000 btu/hr.

Now the longest supply hose we have is 12 feet like with the part # 37207-31365 which would not cover 50 feet and we aren't able to determine what fitting your generator may need so you might confirm that and we can go from there.

expert reply by: Jameson C

0

Answer 1

To connect your Champion #100165 Dual Fuel generator to a 100 pound propane tank, the manufacturer states that "The generator can be attached a larger propane tank. The generator requires ½ PSI with a flow rate of 152,000 BTU/hr.…

view full answer...

Answer 2

Grease Seal #RG06-050 is the replacement part for the Dexter 010-019-00. It is 1.719 inches inner diameter and 2.565 inches outer diameter. It is a fit for 3500 lb axles. This is a confirmed replacement cross-reference.

view full answer...

Answer 3

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

view full answer...

Answer 4

Instead of 7.50-16LT (Light Truck) tires, you will want to put trailer tires on your trailer. Trailer tires have a stiffer sidewall which allows them to carry heavier loads better than a passenger car tire. Passenger car tires have some flex in their…

view full answer...

Answer 5

The Karrier ST235/85R16 Radial Trailer Tire - Load Range E, item #AM10295, is the closest tire to the 7.50-16LT tire that we have. Your tire has an overall height of 31.8 inches and a section width of 8.4 inches. The #AM10295, tire has and overall…

view full answer...

Answer 6

Yes, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4645V is a direct replacement for a Magnetek Model 6345 Converter.

view full answer...

Answer 7

Yes, you do have the exact right replacement converter for your 45 amp Magnetek 6345, which is the option from Progressive Dynamics: - Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V I have added links below to…

view full answer...

Answer 8

I do have a camera system that will tie into the factory in-dash monitor on a 2010 - 2019 Ram 3500 with the Truck Bed Cargo Camera for Factory Monitor part #3460015 but this as I am sure you can see installs on the vehicle and is used predominantly…

view full answer...

Answer 9

The only 5th wheel tailgates available for your 2018 Ram 2500 are the Stromberg Carlson 4000 Series #VGD-10-4000 and 100 Series #VGD-10-100. You can add the Insert Kit #4000-V to the 4000 Series to gain a little more privacy. While neither of these…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Regulator for Generac Propane Generator

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching