Recommended SumoSprings for a 2017 Ford F-150

Question

Question:

I have a 2017 Ford F150 FX4 crew cab truck and tow a 2019 Phoenix 819 pro 20 foot bass boat, Mercury 200 pro xs motor and tandem axle trailer and I am wanting advise on which model of sumo springs to install to prevent sagging in the rear when I tow but I want my truck to remain level when not towing the boat. I do not want any lift in the rear at normal stance. Thanks for the advice..

asked by: Jack B

1

Helpful Expert Reply:

The SumoSprings Solo Custom Helper Springs part # SSR-117-47 are what I recommend for a 2017 Ford F-150. These springs are the perfect balance of support and comfort. They will not raise the ride height in any way. They are only engaged while loaded.

expert reply by: Conner L

1

Answer 1

To see where the TorkLift HiddenPower Under-Vehicle Battery Mount with Battery Box #TLA7728 that you referenced will mount check out the picture I attached. It basically will attach to the passenger side frame rail just to the front of the leaf…

view full answer...

Answer 2

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 3

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 4

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 5

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 6

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

Yes, the Curt hitch part #C77ZV is a fit for the 2023 Toyota Crown Hybrid. I attached a link to the install instructions as well as a link to an installer finder in case you wanted to find someone near you to install the hitch.

view full answer...

Answer 9

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 12

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Recommended SumoSprings for a 2017 Ford F-150

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching