Recommended 2.441" EZ Lube Grease Cap With 1.18" Opening
Question:
I am looking for a wheel bearing cap that will fit into a 62mm hub 2 and 7/16 that has a minimum 25mm 1 cavity
asked by: Ken M
0
Expert Reply:
It sounds like you are looking for the 2.44" OD EZ Lube Grease Cap # 21-42-1 which will fit your 62mm (2.441") hub and has a 1.18" (29.97mm) opening for EZ lube bearings.
You will also need Grease Cap Plug # RG04-010 to plug the holes to keep dirt and other debris from getting in the hub.
I included a video for both of the products mentioned for you to take a look at.
expert reply by:
Samuel C
0
Products Referenced in This Question
Grease Cap Plug for E-Z Lube Grease Caps - Qty 2
- Accessories and Parts
- Trailer Bearings Races Seals Caps
- Plugs
- TruRyde
more information >
Product Page this Question was Asked From
2.44" OD EZ Lube Grease Cap - Drive In - Qty 1
- Trailer Bearings Races Seals Caps
- Caps
- E-Z Lube Grease Cap
- 2.441 Inch O.D.
- Redline
more information >
Continue Researching
- Q&A: Trailer Hitch & Wiring Harness for 2008 Infiniti FX35
- Article: Trailer Wiring Diagrams
- Q&A: Wiring Diagram for Dometic Single Zone Thermostat and Control Box
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement EZ Lube Grease Cap For Trailer Hub on 4,400 lb Dexter Axle
- Q&A: How To Tell If I Have An EZ Lube Axle
- Q&A: EZ Lube Grease Cap Recommendation for Part Number 021-042-01
- Q&A: Troubleshooting a Dragging Electric Brake on a Trailer
- Q&A: Replacement Bearing Kit for a Dexter 4,400 lbs Axle
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Troubleshooting Brake Controller Installations