What is the Offset of the Kenda 5.70-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 # AM30140

Question

Question:

hi whats the offset on these wheels?

asked by: Chris

0

Expert Reply:

The wheel that comes with the Kenda 5.70-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 # AM30140 that you referenced has a zero offset.

expert reply by: Jameson C

0

Answer 1

As long as you have clearance for the additional width of the wheel and tire and for the additional height of the tire, you can use the Kenda 215/60-8 Bias Trailer Tire, item #AM3H290, which has a 7 inch wide, 8 inch diameter White Wheel, 4 on 4 inch…

view full answer...

Answer 2

I do not think the diameter of the tire will pose any problem since a 215/60-8 tire is only about .20 of an inch bigger diameter. The problem you may have is the width of the rim. the width of a rim for the 5.70-8 wheel is 3-3/4 inches and the width…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 7

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Answer 10

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 11

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

What is the Offset of the Kenda 5.70-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 # AM30140

Product Page this Question was Asked From

Continue Researching