Recommended Easy to Install Trailer Wiring Harness for 2002 Nissan Frontier

Question

Question:

Hello im looking to buy a trailer wiring kit for my 2002 nissan frontier it does not have any towing package what item number will work ? I tried to wire my own way but wasmt succesfull thank u for ur time

asked by: Frank

0

Expert Reply:

In order to add trailer wiring to your 2002 Nissan Frontier without the tow package I recommend using the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118362. This will give you a 4 way wiring harness to tow a small trailer without brakes on your Frontier and Tekonsha harnesses are extremely reliable over time. This harness installs easily by teeing into your vehicle lights and there isn't anything that needs to be hard wired like the last harness, so there's nothing to worry about when it comes to installation.

I've linked a short review video of this harness, as well as a link to all of our available ball mount kits in case you don't have a ball mount, hitch ball, hitch pin and clip to give you a complete towing package.

expert reply by: Erik B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 5

The main difference between a Class III hitch and a Class IV hitch is the capacities they set for the hitches. Class III hitches are rated for up to 6,000 lbs GTW with 600 lbs TW whereas a Class IV is rated for up to 12,000 lbs GTW and 1,000 TW.…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

It sounds like you are looking for a trailer hitch for your 2002 Nissan Frontier Crew Cab Long Bed. For that you will want the Draw-Tite Class 3 Trailer Hitch #75186.

view full answer...

Answer 8

The tires in your size that we offer have varying pressure ratings depending on their load capacity. For example, if you look at the tires in your size shown on the link I have included you will see that those rated for Load range E, such as…

view full answer...

Answer 9

Curt trailer hitch #13842 does NOT fit the 2002 Nissan Frontier long bed according to Curt. However we do have a hitch that fits all models of the 2002 Nissan Frontier, long or short bed, 2 or 4 door. Take a look at Draw-Tite trailer hitch #75186.…

view full answer...

Answer 10

Yes, the T-One Vehicle Wiring Harness item #118362 will work with LED tail lights so long as the original factory wiring is still being used. This harness is custom fit for the 2002 Nissan Frontier and plugs into your Nissan's wiring…

view full answer...

Answer 11

For trailer wiring for your 1998 Nissan Frontier I have a much better solution for you than a universal wiring kit like the part #HM48895 that you referenced. You would want the Tow Ready wiring harness part #118362 instead. This is a custom fit…

view full answer...

Answer 12

Your vehicle requires a converter to convert the trucks 5-Wire system down to the 4-Wire system used on trailers. You will find a connection point behind the rear bumper on the passenger side frame rail, that you will use to plug in the Plug-N-Tow…

view full answer...

Recommended Easy to Install Trailer Wiring Harness for 2002 Nissan Frontier

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching