Tekonsha Custom Fit Vehicle Wiring - Trailer Hitch Wiring - 118362 Review Video

Yes, the T-One Vehicle Wiring Harness item #118362 will work with LED tail lights so long as the original factory wiring is still being used. This harness is custom fit for the 2002 Nissan Frontier and plugs into your Nissan's wiring harness,…

Your vehicle requires a converter to convert the trucks 5-Wire system down to the 4-Wire system used on trailers. You will find a connection point behind the rear bumper on the passenger side frame rail, that you will use to plug in the Plug-N-Tow…

Unfortunately a trailer wiring converter module like #118426 can go bad at any time without any notice. It is rare, but can happen. The module has a circuit board that will work great until it doesn't and if that goes, it can do some odd things…

Since the lights work on a different trailer then like you said the issue must be on the trailer. To determine the issue you will first want to check the trailers connector. If there is any dirt or corrosion you will need to clean it out on the pins…

The Kenda Trailer Tire with Galvanized Wheel #AM30630 is a bias tire which has cords inside which run at a 32 degree angle to the direction of travel for a stiffer sidewall than a radial tire. This tire has the standard speed rating of 65 mph.…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

We do carry wheel/tire combos to replace your wheels on your 1980 travel trailer. I have attached a link to the combos we offer that have a 4 on 4 bolt pattern you can check out. One of the combos I recommend is the Kenda 4.80-12 Bias Trailer Tire…

When it comes to upgrading your 4.80-8 tire to a 4.80-12 the width of the tire and bolt pattern will be the same so it can be switched. The difference is height is 4.6 inches. I recommend The Kenda 4.80-12 Bias Trailer Tire with 12 inch Galvanized…

Sounds like you have a ground issue on your trailer. Ground problems normally show up when there is more draw on a system such as when you have the running lights on and then use another function like a turn signal or brake light but can show up any…

A standard 7-way is going to work just fine on your trailer. That converter circuit will be for a 12 volt power source which a 7-way is going to have on the 1:00 pin. For the trailer side you would want the part #H20043 and you would be good to go.

Most often the root cause for issues with trailer lighting is a weak ground. Strange as it may sound, a loose or rusty/corroded ground can cause a vehicle's trailer wiring harness to badly misbehave and shut down some functions. It may also just…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…