Curt Safety Chain Anchors that Fit 2018 Ford F-450 with OEM Rail Kit

Question

Question:

Are you sure that C60691 fits the 2018 F450 puck system?

asked by: Roy C

1

Helpful Expert Reply:

Yes we know for sure that the Curt safety chain anchors part # C60691 are a confirmed fit for your 2018 Ford F-450 with the OEM rail kit.

expert reply by: Jameson C

1

Answer 1

You can install a truck bed mat in your 2017 Ford F-250 with the factory 5th wheel/gooseneck prep so long as you trim the mat to allow full metal-on-metal contact of the hitch to the installation rails. There cannot be any part of the mat trapped…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 6

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 7

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Answer 8

So for your set up, a 2021 Ram 2500 short bed with the RamBoxes, you will need to use a Sidewinder in order to have the clearance to tow a 5th wheel. The Goose Box doesn't move the pivot point and an offset ball just won't be enough for…

view full answer...

Answer 9

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 10

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

view full answer...

Answer 11

I recommend using the B&W Ball and Safety Chain Kit #BWGNXA2061 for the factory puck system on your 2020 Ford F-350 Super Duty. I like this kit of the Curt #C60692 and Reese #RP30137 options because it uses a handle to secure the gooseneck hitch…

view full answer...

Answer 12

Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a 2" receiver we do have the B&W #BWRHXA2182 if you need to use your 2" ball mount or hitch mounted…

view full answer...

Curt Safety Chain Anchors that Fit 2018 Ford F-450 with OEM Rail Kit

Product Page this Question was Asked From

Continue Researching