5K Capacity Bulldog Jack Is Jammed and Will Not Raise or Lower Trailer
Question:
I have a Bulldog Max Capacity of 5,000 lbs lift and 8,000 lbs static and will not crank down or up, what are the parts i would need for this?
asked by: Adam G
Expert Reply:
According to Bulldog, the jack has been either over extended or retracted and the main screw inside that runs the jack in and out has jammed into the nut. If using a reasonable amount of force won't successfully retract or extend the jack, then Bulldog recommends that the jack be replaced as the screw has been damaged and a replacement part isn't available.
The closest replacement to your original jack is part # PS1400800383.
![Mike L](https://images.etrailer.com/static/images/catg/people/166_tn.jpg)
Products Referenced in This Question
Pro Series Square Jack with Footplate - Drop Leg - Topwind - 28-5/8" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Topwind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Product Page this Question was Asked From
Replacement Gears for Bulldog Sidewind Trailer Jacks with 5,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Cap for etrailer and Ram Square, Direct Weld, Sidewind Jack - 10K
- Shop: Blaylock EZ Lock Gooseneck Coupler Lock - RAM Gooseneck Couplers - Aluminum
- Shop: EZ Lock Gooseneck Coupler Lock Combo - Bulldog/Stallion/Superior/T.E.M. Gooseneck Couplers
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Topwind - 29" Lift - 7,000 lbs
- Shop: Square Pipe Mount Swivel Jack w/ Footplate - Weld On - Topwind - 15-1/2" Travel - 3,000 lbs
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Shop: Pro Series Square Jack with Footplate - Drop Leg - Topwind - 28-5/8" Lift - 5,000 lbs
- Q&A: Replacement Motor for Bulldog Landing Gear Motor 1046104
- Video: Pro Series Trailer Jack - Side Frame Mount Jack - PS1400800383 Review
- Search Results: bd500171
- Search Results: bd500156
- Shop: Base Plate for Tow Bar
- Shop: Front Mount Hitch
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Wiring Diagrams
- Search Results: 25580
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: dust cap
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Vehicle Tow Bar Wiring
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Search Results: 44649
- Search Results: equalizer
- Shop: Brake Controller
- Video: B and W Hitch Ball - Trailer Hitch Ball - BWHB94005 Review
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)