Best Budget Trailer Wheel and Tire in Size ST215/5R14 with 5 Lug Wheel

Question

Question:

I need to match a st215/75R14 tire and rim, 5 by 4 1/2 on a tight budget. What and where are my best options?

asked by: Ralph G

0

Expert Reply:

The best value for the money for a trailer tire in the size ST215/75R14 with a 5 on 4-1/2 inch bolt pattern is the part # AM32181 as it's a radial tire in this size with a solid weight capacity of 1,870-lb maximum load at 50 psi and a higher speed rating of 81 mph.

expert reply by: Jameson C

0

Answer 1

The main difference between a ST205/75-14 size tire like the Contender #AC14R45SM and a ST215/75-14 size tire like the Taskmaster Provider Item #TTWTR21514 is that the larger number is a slightly larger size. The 205 has a section width of…

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 5

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 6

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this…

view full answer...

Answer 7

The wheels for your ST215/75R14 sized tire on your 2022 Coleman Lantern 17B are 14" X 5-1/2" wheels with a 5 on 4-1/2 bolt pattern. The Karrier ST215/75R14 Radial Trailer Tire with 14" Galvanized Wheel - 5 on 4-1/2 - Load Range C, part…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Best Budget Trailer Wheel and Tire in Size ST215/5R14 with 5 Lug Wheel

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching