Clearance Needed to Install Lippert Tailgate Storage System

Question

Question:

Hello. Do you know the dimensions of these brackets? Trying to find out if they will fit between my bumper and RV body. I need the height of the bracket in the middle of the bracket. Thank you.

asked by: Todd M

0

Expert Reply:

I checked with Lippert and they told me that the Lippert Tailgate Storage System Mounting Kit # LC432336 that you referenced requires 4 inches between the bumper and the back of the trailer.

expert reply by: Jameson C

0

Answer 1

The Lippert Tailgate Storage System Mounting Kit part #LC432336 attaches to the frame which you can see below. Therefore, so long as the wall does not extend past the frame rails too much it should work. The included diagrams below should help to…

view full answer...

Answer 2

The Lippert Components Flip Down Slotted Bike Rack Tailgate Storage System #LC243621 that you referenced weighs 74 lbs. I attached a review video link on this page for this for you to check out as well.

view full answer...

Answer 3

The brackets part #LC373965 that you referenced basically either bolt around or weld to the bumper support beam on the RV. I attached a picture that shows them welded but you could also drill holes in the bumper and use included hardware to secure…

view full answer...

Answer 4

I spoke to Lippert about the Lippert Components Flip Down Slotted Rack Tailgate Storage System part #LC243621 and they do not list a specific number of bikes that can be used. The reason for this is that it can vary greatly based on what type of…

view full answer...

Answer 5

The Lippert Tailgate Storage System Mounting Kit part #LC432336 is designed to be used with the Lippert Components Tailgate Storage System part LC404069 (Not Currently Available) or part #LC243621.

view full answer...

Answer 6

The Lippert #LC373965 install hardware kit for the #LC243621 flip-down tailgate storage system isn't vehicle specific. The hardware kit is designed to bolt or weld to the 2 inch wide frame extensions, as is shown in the provided photo. If the…

view full answer...

Answer 7

Please see the attached image for the requested measurements of the Lippert Tailgate Storage System Mounting Kit, #LC432336. The measurements are as follows: Orange (overall length): 26-1/2 inches Brown (width of the bend on the back of the bracket):…

view full answer...

Answer 8

I checked with Lippert and they told me that the Lippert Tailgate Storage System Mounting Kit #LC432336 that you referenced requires 4 inches between the bumper and the back of the trailer.

view full answer...

Answer 9

The Lippert #LC432336 is designed to fit on a variety of trailers, but we don't have specific fit information for each individual trailer. The #LC432336 is designed to fit on trailers that do not have the 4 inches of clearance required to install…

view full answer...

Answer 10

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

view full answer...

Answer 11

Yes, the Lippert Components Flip Down Slotted Bike Rack Tailgate Storage System part #LC243621 uses the same mounting brackets as the Lippert Components Tailgate Storage System.

view full answer...

Answer 12

Yes we do carry the Lippert Components Flip Down Slotted Rack Tailgate Storage System #LC243621 that you referenced! This is a bumper mounted fold down rack with a 200 lb capacity.

view full answer...

Clearance Needed to Install Lippert Tailgate Storage System

Product Page this Question was Asked From

Continue Researching