Titan Brake Actuator Master Cylinder Replacement Gasket

Question

Question:

Do you place the sticky side of the master cylinder gasket against the master cylinder or against the bottom of the coupler where the master cylinder attaches? Thanks

asked by: Don M

0

Expert Reply:

For ease of installation you can stick the gasket to the master cylinder, so that it is aligned with the mounting holes. Be sure to clean the surfaces before mounting so you get a good seal and start the mounting bolts by hand to ensure proper alignment.

expert reply by: Robert G

0

Answer 1

Brake actuators designed for drum brakes typically produce around 1,000 psi pressure at most, while disc brake actuators will produce closer to the 1,600-psi pressure that you mentioned in your question. I do not recommend using a disc brake…

view full answer...

Answer 2

Locking out a Titan Model 60 actuator like the part #T63FR that you referenced requires inserting the lock out tool into the into the slot right behind the portion of the coupler that inserts into the outer casing. I pointed out where in the…

view full answer...

Answer 3

For your Titan Model 60 disc brake actuator the correct master cylinder is the part #T4820000.

view full answer...

Answer 4

Attached is a clip from the instructions on how to bleed the brakes after installing the Demco Hydraulic Brake Actuator #DM8204311 that you referenced. You can use the Powerbuilt Brake Bleeder #ALL648591 to assist you in this process.

view full answer...

Answer 5

It's definitely way less work to keep what you have, surge brakes, than it is to convert everything to electric. Personally I'd just stick with surge brakes, as the only benefit you really get to electric brakes is the adjustability of the…

view full answer...

Answer 6

Turning the wheel so that the teeth on the wheel move upward will expand the brake shoes against the inside of the brake drums. Moving the teeth downward will contract the brake shoes. You can see the adjustment procedure by clicking on the video…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Waylon, it does look like the Dexstar Steel Mini Mod Trailer Wheel #AM20539 is the same thing as the Dexstar 17-233 wheels you're referring too. These are silver wheels with a 6 on 5 1/2 bolt pattern, a 0 offset, and are made in the USA.

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

The etrailer E-Track Roller Idler #e67HR is 3" from the top of the e-track to the bottom of the roller.

view full answer...

Titan Brake Actuator Master Cylinder Replacement Gasket

Product Page this Question was Asked From

Continue Researching