Puck Light Replacement for RV Ceiling that is 3-3/4 inches Diameter

Question

Question:

I am looking for puck lights that are 3.75inch on the front and 2.75inch on the back. There are 2 wires on the back and there are two clamps that hold it to the roof.

asked by: Mike

0

Expert Reply:

In the spring mount style of puck light the closest option we have is the part # DG52445VP that you referenced but would require you to slightly open up the holes in your ceiling if what you have is 2-3/4 inches in diameter as this needs a 3 inch hole.

expert reply by: Jameson C

0

click to enlarge

Answer 1

What you have appears to be a standard puck light which you could use the part #277-000343 as a replacement for if it's 3 inch in diameter like it looks like. We also have 4-1/2 inch size like part #277-000344 but it does look to me like you…

view full answer...

Answer 2

The gear that you're talking about on your MaxxFan 4401K is the operator mechanism. For a replacement you need the #MA10-20281K-1AF.

view full answer...

Answer 3

While we do not carry the L9100 light you are asking about, or replacement parts for it, we do have similar replacement options such as the 2" Recessed Halogen Puck Light with Frosted Glass, #277-000125 and the LED RV Puck Light - Recessed…

view full answer...

Answer 4

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Puck Light Replacement for RV Ceiling that is 3-3/4 inches Diameter

Product Page this Question was Asked From

Continue Researching