Can RhinoEXTREME Sewer Hose Fit Into Valterra RV Sewer Hose Carrier # A04-5094

Question

Question:

Will a Camco RhinoEXTREME sewer hose fit inside this? Interior diameter of the tube vs exterior diameter of the RhinoEXTREME hose. Thanks

asked by: Mike

0

Expert Reply:

Yes a RhinoEXTREME sewer hose will easily fit into the Valterra RV Sewer Hose Carrier # A04-5094 that you referenced. This has an inner diameter of 4-1/2 inch and the RhinoEXTREME has an outer diameter of 4 inch.

expert reply by: Jameson C

0

Answer 1

The Valterra RV Sewer Hose Carrier #A04-5094BK referenced in your question can be safely adjusted to a length of up to 94 inches. The tube has an outer diameter of 5 inches and will simply mount to the frame of your NorthTrail Trailer using the…

view full answer...

Answer 2

The brackets of the Valterra EZ Hose Carrier #A04-5094BK that you referenced are built into the end caps of the carrier so they are not adjustable.

view full answer...

Answer 3

When fully compressed each of the hoses that come with the RhinoEXTREME #CAM39867 will measure 54 inches minus the elbow as that wouldn't fit in a RV bumper.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

view full answer...

Answer 9

There is a difference between a 7-way round and and 7-way rv blade connector. If you take a look at the accompanying photo, which is from our linked article on trailer wiring you can see that the connector on the left has blade-style pins while the…

view full answer...

Answer 10

Yes we do have a set of Timbrens that fit your 2024 Toyota Tundra with the part #T45MR. These can give you up to an additional 6,000 lbs of suspension support.

view full answer...

Answer 11

The recommended minimum clearance between gooseneck trailer overhang and truck bed rails is 4-6 inches. I'd recommend 6 inches but a lot of people get by with just 4. Ideally you have at least 6 inches of clearance and the trailer is sitting…

view full answer...

Answer 12

Yes, anytime you use a hitch extender or reducer like #HR26 you will lose about 1/3 of your hitches overall capacity. However, since you'll be towing a trailer that weighs between 4,500 to 5,000 lbs, the Brophy Hitch Reducer #HR26 will still work…

view full answer...

Can RhinoEXTREME Sewer Hose Fit Into Valterra RV Sewer Hose Carrier # A04-5094

Product Page this Question was Asked From

Continue Researching