Do the Andersen AlumiBalls For Their Rapid Hitch Fit The Ultimate Connection Hitch?

Question

Question:

Wondering if Andersen 3453 or 3453-25 balls can be fit right into the base for this #3209.Do the Andersen Alumiballs for their Rapid Hitch fit?

asked by: John

0

Expert Reply:

The Andersen Ultimate Connection 5th Wheel Trailer Hitch System with Adapter - 20,000 lbs # AM3200 uses hitch ball # AM3201 only. It is not compatible with the greaseless AlumiBall # AM3453 which is only compatible with the Rapid Hitch Ball Mount options.

expert reply by: Jason S

0

Answer 1

The Replacement Ball for Andersen Ultimate Connection 5th Wheel Trailer Hitch System - 2-5/16 Item #AM3201 has the same weight rating of the adapter it fits of 20,000 lb capacity.

view full answer...

Answer 2

When replacing keys on your Anderson Rapid Hitch Lock #03003 we do not currently have the keys available for your exact core. The best option that we would have is for you to buy a whole new lock and cutting off the existing lock. The Andersen…

view full answer...

Answer 3

It should be getting close to 12 volts if the power output is set to the maximum on the brake controller. Some brake controllers will not work properly if they are titled or turned to the side or if it has a leveler knob that is not level. Check…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 11

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 12

The recommendation for the 10" diameter lube plate on a B&W Companion 5th Wheel Trailer has come from the manufacturer of the fifth wheel hitch, B&W. The Lube Plate for Reese 5th Wheel Trailer Hitches part #RP83002 will work just fine…

view full answer...

Do the Andersen AlumiBalls For Their Rapid Hitch Fit The Ultimate Connection Hitch?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching