Automatic Changeover Propane Regulator for Dual Tank Setup on RV

Question

Question:

converting from single tank to dual tank, RV 2016 Jayco 174BH you list quite a few regulators ,what is the difference between them and what is recommended for my application Thank You

asked by: Stephen G

0

Expert Reply:

We do have a few options but the regulator setup that I recommend is the part # CAM59005 which will automatically switch between the two tanks without any input from you at all. This is a compact and very reliable unit that will work great for you.

expert reply by: Jameson C

0

Answer 1

Since at full load your 20 kw generator would consume 337,500 btu you'd need something rated higher than the Camco you mentioned and instead would want the part #37207-30395.

view full answer...

Answer 2

The Automatic Changeover RV LP Gas Regulator #37207-30395 will work in place of the winntec model 6020 with no issues at all. With pigtails I suggest the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT - 20" #100473-20-MBS.

view full answer...

Answer 3

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 4

In reality, both the #37207-31525 and the #37207-30395 would be acceptable replacements since most folks aren't going to be utilizing that much gas at the same time; even running all of your gas powered appliances at the same time on maximum…

view full answer...

Answer 5

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 12

I added a photo which shows the location of the heating element of the Atwood Water Heater GC6AA-10E for you. It is item number 17 in the diagram. Atwood does recommend having a professional do the job if you are replacing it due to its location.

view full answer...