RV Regulator that can be Used with 20 KW Generator that Consumes 337,500 BTU

Question

Question:

Will the cam59005. Work with this fuel consumption. In photo

asked by: Phillip D

0

Expert Reply:

Since at full load your 20 kw generator would consume 337,500 btu you'd need something rated higher than the Camco you mentioned and instead would want the part # 37207-30395.

expert reply by: Jameson C

0

Answer 1

If you had a TorkLift GlowStep Stow N' Go #TLA7834 installed and when it was fully deployed it wasn't touching the ground you'd run risk of bending or breaking the setup. If it was a lower height than usual the steps would just basically…

view full answer...

Answer 2

The cap you're looking for is the larger of the two on the MB Sturgis High Capacity Two-Stage Auto Changeover Regulator #888001-MBS. You'll have to remove two caps to access the adjustment screw but this really should only be done by a…

view full answer...

Answer 3

To connect your 100-lb propane tank to your generator, you'll need an adapter like #204051-MBS. Then you'll just need a hose to go from your tank to the generator. A lot of generators utilize the quick disconnect connector, if that's the…

view full answer...

Answer 4

To verify which regulator would be the best choice for your 2022 Outdoors RV Mountain Series Blackstone 280KVS you will need to verify exactly how many BTU's all of your propane appliances and accessories will require. Unfortunately, Outdoors RV…

view full answer...

Answer 5

In reality, both the #37207-31525 and the #37207-30395 would be acceptable replacements since most folks aren't going to be utilizing that much gas at the same time; even running all of your gas powered appliances at the same time on maximum…

view full answer...

Answer 6

Essentially each regulator is going to give you an 11" WC (pressure rating) but the amount of BTU's (in this case we'll say fuel) can differ greatly. The JR Products Regulator #37207-30395 is giving you 345,000 BTU's per hour at…

view full answer...

Answer 7

For your 30,000 BTU wall mounted heater you will need to use a dual-stage propane regulator. The correct regulator will be the MB Sturgis Vertical 2-Stage Propane Regulator - 11" Water Column Outlet #108220. You will need a vertical regulator if…

view full answer...

Answer 8

Yes, the BTU output is the same on both of your propane tanks when using the Automatic Changeover RV LP Gas Regulator #37207-30395.

view full answer...

Answer 9

We do have a few options but the regulator setup that I recommend is the part #CAM59005 which will automatically switch between the two tanks without any input from you at all. This is a compact and very reliable unit that will work great for you.

view full answer...

Answer 10

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 11

The Automatic Changeover RV LP Gas Regulator #37207-30395 will work in place of the winntec model 6020 with no issues at all. With pigtails I suggest the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT - 20" #100473-20-MBS.

view full answer...

Answer 12

I checked with JR Products to find out what the adjustment pressure range is for the Automatic Changeover RV LP Gas Regulator #37207-30395 and they sent me the attached graph.

view full answer...

RV Regulator that can be Used with 20 KW Generator that Consumes 337,500 BTU

Product Page this Question was Asked From

Continue Researching