Torque Ratings of U Bolt Nuts with 3/8 diameter

Question

Question:

What is torque specs of the SP01-020 U bolt nuts

asked by: Bill

0

Expert Reply:

I called the manufacturer and they said that the minimum torque is 45 ft. lbs. and the maximum is 70 ft. lbs for the Dexter U-Bolts # SP01-020.

expert reply by: Jameson C

0

Answer 1

If you have a 7 Way connection, the 2 o'clock position will be your 12 volt power, the 3 o'clock position will be the right turn signal and right brake signal, the 5 o'clock position will be your brake controller output, the 7…

view full answer...

Answer 2

There is power running to both sides at the same time on the Pollak 7- and 4-Pole Trailer Connector #HM40975. However, using both at the same time could result in over drawing power which could lead to blown fuses, electrical fire, accessories not…

view full answer...

Answer 3

The correct torque spec for trailer suspension u-bolts will depend on the the diameter of the bolt. You will want to use the following depending on bolt size: 1/2" bolts: 45 ft/lbs - 70 ft/lbs 9/16" bolts: 65 ft/lbs - 95 ft/lbs…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 10

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Normally the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR install on outsides of trailer frame. I attached an install video for this for you to check out as well.

view full answer...

Torque Ratings of U Bolt Nuts with 3/8 diameter

Product Page this Question was Asked From

Continue Researching