Replacement U-Bolts Compatible with CE Smith U-Bolt Kit for 1-1/2 Inch Square Axle

Question

Question:

All I need are 16 of the bolts and nuts, not the plate. Is this possible? What would the cost be? Length can be 2inch to 4 Thanks

asked by: Mike F

0

Expert Reply:

The CE Smith U-Bolt Kit for Mounting 1-1/2" Square Trailer Axles - 3-3/8" Long U-Bolts - Zinc # CE23102 unfortunately doesn't have direct replacement parts outside of the kit. The Replacement U-Bolt with Nuts for 1-1/2" Wide, Square Trailer Axles - 1/2" Diameter # 1753223 is the closest we have to what you are seeking but it is not zinc plated and is 5 inches long.

expert reply by: Jason S

0

Answer 1

As long as the axle the won't exceed 5,000 lbs the trailer leaf spring #e44SR would work great since it has a 5k capacity. If you need the full capacity of your axles you'd have to move up to a 6k spring with the part #e34SR instead. This…

view full answer...

Answer 2

Though it is not completely necessary to use something like Loctite's Threadlocker #LT37420, there wouldn't be any adverse affects either. Most U-Bolt kits do come with lock nuts making them more secure than standard nuts, but you can…

view full answer...

Answer 3

There is no specific torque rating for shackle bolts. Basically for the middle bolt there should be enough free play in the shackles to allow them to move. Tightening the shackle bolts too much will squeeze the shackle straps against the leaf springs…

view full answer...

Answer 4

In order to find the correct replacement leaf spring for a trailer you first need to start by noting the type whether that be slipper or double eye. Then, you'll need to measure their unloaded length via jacking up the trailer. If the springs are…

view full answer...

Answer 5

The torque specs for a 1/2" trailer suspension u-bolt like the CE Smith U-Bolt Kit part #CE23003 is between 45 ft/lbs - 70 ft/lbs.

view full answer...

Answer 6

For 1/2 inch trailer u-bolts that attach to axle the recommended torque value is between 45 and 70 ft lbs of torque.

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 11

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 12

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Replacement U-Bolts Compatible with CE Smith U-Bolt Kit for 1-1/2 Inch Square Axle

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching