Do Hub and Spigot Connections Need to be Cut Off to Swap Out Drain Valve

Question

Question:

I need to replace a grey water valve in my 2010 Cedar Creek. To I have to use the hub and spigot. Both are already glued in for the original

asked by: Steve S

0

Expert Reply:

It depends on what type of waste valve you currently have. If you have a Valterra Bladex then you can replace the waste valve body with part # T1001VP for a 1-1/2" diameter or part # T1003VPM for a 3" diameter. If you have a different brand or you aren't able to swap out the valve body then you will need to replace it with the hub and spigot ends like part # 34466N11AB36GM or # 34466N4AB36GM respectively.

expert reply by: Jon G

0

Answer 1

It sounds like the Fastway e2 #FA94-00-0800 or #FA92-00-0800 is the correct system for your 1/2 full trailer but not for your loaded trailer. You want a system rated for total tongue weight which includes the tongue weight of your trailer and any…

view full answer...

Answer 2

The LaSalle Bristol Cable-Actuated RV Waste Valve, #34466N4AB120GM is not designed to be trimmed. However, there are multiple lengths available: - 36" Cable #34466N4AB36GM - 48" Cable #34466N4AB48GMA - 72" Cable…

view full answer...

Answer 3

The Valterra RV Waste Valve, part #T1001B has an inside diameter of 1.9 inches and the outside of the port measures 2.37 inches. I went to our warehouse and measured the waste valve for you. I have attached a photo of the valve with the dimensions…

view full answer...

Answer 4

For a Horst Probe for a black water tank you would want the part #T21301VP for a quantity of 4 or for a gray water tank you would need the part #T21302VP. The probes of these kits are straight and are not a knock-off. There was a design change though…

view full answer...

Answer 5

Depending on the brand of the gate valve you will either be able to replace just the cable and handle or will have to replace the entire valve/cable/handle. LaSalle Bristol builds the cables into the housing for the valve, making them essentially…

view full answer...

Answer 6

I looked up the Bristol V33B2R and the correct replacement is the Bristol RV Waste Valve - Sewer Wye - Rotating - 3" and 1.5" Hubs to 3" Lug #34466N3AR which has the hub style fittings for the 3 inch and the 1.5 inch sections which…

view full answer...

Answer 7

To find a replacement you'll need to remove the door lock from the door and measure the cutout hole. The portion of the handle that's inside your trailer should have some screws you can remove to take the lock apart and gain access to the…

view full answer...

Answer 8

To replace your Shurflo 2088-422-174 fresh water pump, I recommend the Flow Max RV Fresh Water Pump #LC689052 instead of the HydroMax RV Fresh Water Pump #P25201 because the Flow Max will draw a maximum of 8 amps, as opposed to the 10 amps of the…

view full answer...

Answer 9

Looking more closely at the product pictures we have for the Valterra Bladex Waste Valve #T1003VP you can see the gaps in those pictures as well. It's a fairly common question with this design, but the rubber gaskets are designed to prevent…

view full answer...

Do Hub and Spigot Connections Need to be Cut Off to Swap Out Drain Valve

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching