2012 Jaco Eagle 31.5 RLTS Cushioned Pin Box Replacement

Question

Question:

Looking for a replacement cushioned pin-box, for my 5th wheel. Replacing a Dexter S/N AF7926. I would like it if it were angled a little steeper, as the rear heal swing interferes with some items I carry in the bed of the truck behind the hitch. The existing hitch from the center of the king pin to the first row of holes is 18, there are 6 1/2inch bolts that are 7 inches apart

asked by: Wayne Y

1

Helpful Expert Reply:

Based on dimensions we've had sent to Lippert we know that the Trailair part # UF35-946211 can fit in place of your Dexter AF7926 pin box to provide you with a cushioned replacement.

expert reply by: Jameson C

1

Wayne Y.

6/18/2020

What is the height difference of the Kingpin from my Dexter AF7926 and the UF35-946211 pin-box from the bottom row of mounting holes?

Reply

Chris R.

6/22/2020

I wasn't able to track down specific dimensions for the Dexter AF7926 pin box so I can't give you an exact comparison. I can say though that even though the design on the Trailair is much different, it really shouldn't differ from your existing ride height or bed rail clearance at all.

Reply

Answer 1

What I suspect you actually have on your trailer is a Leland 7920 pin box. But since I can't confirm you will need to check out the FAQ article I attached on determining what pin box you have based on the dimensions. If it turns out you have a…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

Based on the information you gave, although I can't help with the axle (other than to state it is a 3,500 lbs axle). Dexter mobile home axles were designed for one time use and weren't really documented for replacement parts, but because you…

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

It sounds like the 2022 Chevy Silverado 3500 you are getting has the short bed. In that case, yes, you definitely want the sliding 5th wheel hitch for clearance. The good news is you will not need to purchase the entire B&W Companion #BWRVK3775.…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

2012 Jaco Eagle 31.5 RLTS Cushioned Pin Box Replacement

Product Page this Question was Asked From

Continue Researching