Replacement Handle For Pro Series 1,000 Lb Swivel Jack

Question

Question:

Will this handle fit a 1000 lb Pro Series wheeled, swivel jack?

asked by: Barry B

1

Helpful Expert Reply:

Yes, the Replacement Sidewind Handle Kit for Pro Series or Fulton Marine Jacks part # F0933305S00 is exactly what you need for the 1,000 lb Pro Series Swivel Jack like part # PSEJ10000101.

expert reply by: Heather A

1

Answer 1

I like the non-marking rollers like the 4 inch bow roller part #TR450B-400B which fits a 1/2 inch shaft or the #YR300B-325B which is 3 inch wide and fits a 1/2 inch shaft. These two are the standard sizes commonly found so I'd measure what…

view full answer...

Answer 2

It may be possible to get another handle; I would need to know the model number of your jack in order to see if there is a compatible replacement. Do you know the model number of your jack? I was unable to find any reference to a Fulton Maximum…

view full answer...

Answer 3

Both the Fulton 800 lb Handle #F0933301S00 and the 1,500 lb Handle #F0933305S00 have the same diameter so you just need to make sure that the distance from the end of the handle to the pin hole is similar to what you currently have.

view full answer...

Answer 4

I have a 5 inch roller, but the largest Bow Roller Assembly that we offer is a 4 inch, like part #YR450Y-400Y. The CE Smith Deep V Keel Roller Assembly #CE10401G is 5 inches and will accomplish the same task that a bow roller will. The only…

view full answer...

Answer 5

There are several different Fulton jacks that use a sidewind handle like part #F0933305S00, so to make sure we get you the correct parts, I will need a little more information about your jack. Do you know the model number of your jack? Fulton will…

view full answer...

Answer 6

I spoke to my contact at Fulton and he informed me that the Fulton Magnum series jacks were an older line of jacks that had capacities of over 1,000 lbs. Without knowing what capacity your jack is or what model it is it would be hard to pick out…

view full answer...

Answer 7

For your seal dimensions that you listed the replacement seal part #RG06-050 that you mentioned.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 12

Thank you for the pictures! For a replacement option I recommend the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Bolt On - Disc - 2" Ball - Zinc - 7.5K #DX29FR to replace your current actuator. The #DX29FR has a 7500lb trailer weight…

view full answer...