Outer Diameter of Inner Leg of Trailer Valet JXC Trailer Jack part # TV64FR

Question

Question:

What is the outer diameter of the inner tube?

asked by: Warren

0

Expert Reply:

The outer diameter of the inner tube of the Trailer Valet JXC part # TV64FR is 2 inches.

expert reply by: Jameson C

0

Answer 1

The Trailer Valet #TV64FR JXS 5K trailer jack is a pipe mount swivel jack that can be removed from the trailer by pulling the pin shown in the provided photo. If you click the provided link, you can see a video showing a typical installation.

view full answer...

Answer 2

The mounting plate for the Trailer Valet JXS Trailer Jack #TV64FR has bolt holes that are separated on center 5-1/2" horizontally. The vertical mounting holes are separated on center 1" each for a total of 5" from the top hole to the…

view full answer...

Answer 3

We do offer a 5K static/3K lift capacity bolt on jack that would be easily removed. Take a look at the Traler Valet #TV64FR. The jack will fit on frame members up to 4-3/4 inches tall x 3-3/4 inches wide. The jack can be swiveled up so its parallel…

view full answer...

Answer 4

A trailer jack only needs to support the tongue weight, which for a boat trailer is something like 5 to maybe 10 percent of the weight of your loaded trailer, because so much of the weight is at the rear of the trailer. To be absolutely sure you will…

view full answer...

Answer 5

You can use the Trailer Valet JXS part #TV64FR on an I-beam trailer frame but it would need to fit around the I-beam instead of fitting into it.

view full answer...

Answer 6

The Trailer Valet #TV64FR JXS Trailer Jack has a 3000 lb lift capacity, and offers a 14 inch lift. It doesn't feature a drop leg.

view full answer...

Answer 7

?The distance from the mounting plate to the foot on the Trailer Valet JX-2K #TV54FR is 13" when fully retracted. The distance from the mounting plate to the top of the jack is 23". This jack can provide you with up to 14" of lift on…

view full answer...

Answer 8

Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball mount…

view full answer...

Answer 9

The Trailer Valet JXC Trailer Jack #TV54FR that you referenced does not have a drop leg. I attached a picture that shows the jack full extended and you can see there isn't a drop leg. I also attached a review video for more info on this as well.

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Outer Diameter of Inner Leg of Trailer Valet JXC Trailer Jack part # TV64FR

Product Page this Question was Asked From

Continue Researching