Could Timbren and Air Lift Suspension Enhancement Fit 2019 Ram 1500 Classic

Question

Question:

Can you use a combination of part # AL60818 and TDR1500DQ for a RAM 1500 Classic?

asked by: RVJ

1

Helpful Expert Reply:

Technically the Air Lift kit part # AL60818 and the Timbren # TDR1500DQ would fit together as the Air Lift installs in the coil and the Timbren replaces the bump stop but if you were in a situation where you needed the support of both at the same time you are probably overloading the capacity of truck so you might check to make sure you are within the capacity of the truck.

expert reply by: Jameson C

1

click to enlarge

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Rick, thanks for reaching out! The 10K GTW rating of the Fastway e2 Weight Distribution #FA94-00-1000 is the max trailer weight the system can handle. With that being said, when you choose a WDH you need make your selection based off the loaded…

view full answer...

Answer 4

The Husky Center Line Weight Distribution with Sway Control 32217 is for 600 lb to 800 lb total tongue weight capacities (the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your tow…

view full answer...

Answer 5

Hey Kristopher, great question. You have a 2022 Ram 1500 correct? If so, I definitely recommend going with the Air Lift LoadLifter 5000 Air Helper Springs #AL57375. I can confidently say that using these will take care of all of the sagging, and will…

view full answer...

Answer 6

According to the owner's manual for your 2011 Nissan Armada, if the gross trailer weight (GTW) of your trailer is more than 5,000 lbs then the use of weight distribution is recommended. In addition to the weight distribution system, I also…

view full answer...

Answer 7

Drilling down through the truck bed is required for the installation of any 5th wheel trailer hitch mounting kit with above the bed rails for your 2015 Ram 1500 short bed, including #DM8552030-71. But this is a 4-bolt installation kit so you would…

view full answer...

Answer 8

Hi Jeremy; that's a good question and you'll actually need to go ahead and re-do the set up of your weight distribution system after adding the Timbren Rear Suspension Enhancement System #TDR1500DS to your 2019 Ram 1500. So it wouldn't…

view full answer...

Answer 9

The Demco AutoSlide #DM8550040 will work for your 2015 Ram 1500 and 5th wheel trailer. Demco designed this 13K Hijacker AutoSlide 5th Wheel Hitch #DM8550040 with the 6 foot beds in mind. As you turn this hitch will give you an extended distance of…

view full answer...

Answer 10

We have a few options for a fifth wheel hitch for your 2016 Ram 1500 short bed without air suspension. Since your truck bed is short enough to require a slider hitch to allow you to make tight turns the best option is a hitch that slides…

view full answer...

Answer 11

The Demco installation kit #DM8552030-71 is compatible with B&W, Curt, Draw-Tite, Hidden Hitch, Husky, Reese, Pro Series and Valley 5th wheel hitches that fit in industry standard above the bed rails. The Demco kit also will not fit if the truck…

view full answer...

Could Timbren and Air Lift Suspension Enhancement Fit 2019 Ram 1500 Classic

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching