Which Axle Over Under Kit Fits Dexter 3,500 lb Axles

Question

Question:

I have dexter axle 2622227. 3500 pound axles. What over under kit is right for me. I drag along and want to lift it up.

asked by: Jonathan T

0

Expert Reply:

Since you have a Dexter 3,500 lb axle that would indicate that you have a 2-3/8 inch diameter axle and the correct over under kit you need is the # K71-384-00.

expert reply by: Jameson C

0

Answer 1

Unless otherwise stated all trailer tires are rated at a maximum speed of 65 miles per hour. The Karrier ST205/75R14 Radial Trailer Tire #AM32153 that you referenced is no exception and should not exceed 65 miles per hour. You should also note that…

view full answer...

Answer 2

The wheel of the Loadstar ST215/75D14 Bias Trailer Tire with 14" Galvanized Wheel #AM3S560 has a zero offset. I attached an FAQ on trailer tires that you might find informative as well.

view full answer...

Answer 3

The recommended lug nut torque for Loadstar ST215/75D14 Bias Trailer Tire with 14 Inch Galvanized Wheel, #AM3S560, is going to depend on your lug nut size. I have attached a chart which includes the following torque specs: 7/16 inch lug nut, 55-65…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…

view full answer...

Answer 6

When you figure your tongue weight, you find the total of the actual tongue weight of the trailer fully loaded (as towed), and any weight carried behind the rear axle of the tow vehicle. If your tools are stowed in front of the rear axle, their…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Which Axle Over Under Kit Fits Dexter 3,500 lb Axles

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching