Replacement Water Valve for Dometic 510+ and 2010 Series RV Toilet

Question

Question:

Will this valve fit the 510+ and the 2010 models I’ve identified our toilet by the measurements and there so close it could be either one I’m pretty sure it’s the 510+

asked by: Charlie

0

Expert Reply:

Yes, the Replacement Water Valve for Pedal-Flush Dometic RV Toilet # DOM55FR will fit both toilet models (510+ and 2010).

The product model identification label is located on the toilet base under the pedestal cover (see photo), just in case you haven't checked there.

expert reply by: Carla M

0

click to enlarge

Answer 1

How did you measure the existing springs? Because leaf springs will flatten out over time as they wear, the best way to get an accurate measurement of the eye-to-eye length is with the trailer up on jack stands so the axle hangs free. This should…

view full answer...

Answer 2

The studs on the Dexter 7 inc brake assembly, part #23-47, are 1-1/4 inch long with 7/16 - 20 threads. Brake Assembly mounting bolt, part #7-75, is 1-1/4 inch long with 7/16 - 20 threads. The nuts, part #6-17, are also 7/16 - 20. This size is…

view full answer...

Answer 3

We've ran into this issue before, but unfortunately Kwikee/Lippert no longer manufactures that 151332 motor, and I'm sorry to say that they do not offer a replacement. I was unable to find anything about the 131320 part you mentioned either.…

view full answer...

Answer 4

Yes, the Advent Air RV Air Conditioner #ACM135 will replace your current Dometic Duo Therm Quick Cool. This unit is designed to replace an existing Advent Air, Dometic, Coleman Mach, or Carrier air distribution box and thermostat.

view full answer...

Answer 5

I did some checking and confirmed that the Dometic replacement flush valve #DOM55FR is the correct replacement for the Dometic Sealand 210 RV toilet you have.

view full answer...

Answer 6

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Replacement Water Valve for Dometic 510+ and 2010 Series RV Toilet

Product Page this Question was Asked From

Continue Researching