Trailer Wiring Harnesses for a 2005 Honda Accord

Question

Question:

do i have to have a converter for wireing this ehicle and is it included in the kit?

asked by: Rollin C

0

Expert Reply:

There are different wiring harnesses for the 2005 Honda Accord, both of which have a converter box. The converters are already part of the harness so you just need to install the correct one. If you have a 2-door model, use # C56053. For a 4-door sedan use # 118302. I have linked instructions for both.

A converter is needed to convert the 3-wire signal from the vehicle down to a 2-wire signal used by most trailers.

expert reply by: Michael H

0

Answer 1

The best way to determine which amount of rise or drop you need from a ball mount (in order to keep your hitched trailer level for the best handling) is to measure as outlined in the linked article. Since the same wheel size could have more than one…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

Yes the Curt hitch part #C12130 is a confirmed fit for your 2008 Mercury Marquis. Then for trailer wiring the Curt harness part #C59236 would be a great option. It's a universal style harness that will require hardwiring to the taillight wiring.

view full answer...

Trailer Wiring Harnesses for a 2005 Honda Accord

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching