Oil Cap Replacement for Dexter 21-37 Oil Cap

Question

Question:

I am searching for dexter 21 37 or similar .....

asked by: Ghislain

0

Expert Reply:

I spoke with my contact at Dexter and he said the 21-37 oil cap is obsolete and was replaced with the 21-36 oil cap, # RG04-270. This cap includes the o-ring and plug.

expert reply by: John H

0

Answer 1

The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel…

view full answer...

Answer 2

34 inch frame hitch fits are for the cab and chassis model trucks. The part #C15312 does not fit cab and chassis model trucks so it would not be a fit for a 34 inch frame. The part #C15800 is an example of a Curt hitch that does fit a 34 inch wide…

view full answer...

Answer 3

A measurement of 2-3/8" is equal to 2.375" and there are a number of bearing buddies that are close to that measurement. In order to determine the exact replacement you need, you'll have to use a digital caliper such as…

view full answer...

Answer 4

From what I can find of your Jingu 17.5 X 6.75 tire is that it has the same wheel size and bolt pattern as the Americana Modular Wheel w/ -0.5 Offset - 17-1/2" x 6-3/4" Rim - 8 on 6-1/2 #AM22461. It also has the same max load…

view full answer...

Answer 5

I pulled up the owners manual of your 2014 Ford F-150 and it looks like fuse number 67 is the trailer running light circuit so that would be the one you would need to check. It takes a 20 amp fuse.

view full answer...

Answer 6

The #RG04-250 Threaded Cap for Oil Bath Hubs has an outside diameter of 3-3/4 inches measured at the threaded portion as shown in the photo and is designed for 10K Al/KO axles.

view full answer...

Answer 7

The Oil Cap Kit, #RG04-250, has a outside diameter of 3-3/4 inches. It is specifically designed for 10K or 12K AL-KO/Hayes oil bath axles. If you have a different axle, this is not the right cap.

view full answer...

Answer 8

Most trailer wheels have a zero offset. This is because a zero offset allows the wheel to handle the maximum load by distributing the the load equally to both sides of the wheel. To determine if your trailer wheels have an offset, you will want to…

view full answer...

Answer 9

For your Karavan trailer I recommend LED tail lights #STL57RB and #STL56RB. They are a little shorter at 6-1/16 inches but they do mount on studs spaced 2 inches apart on center. they are 3-5/8 inches tall and 2-1/4 inches deep overall. I have…

view full answer...

Answer 10

Both the LED Trailer Mini Clearance #MCL10AKB and Uni-Lite LED Clearance #MCL11RKB will require an 11/16" hole for mounting. These both use the same Grommet #A11GB.

view full answer...

Answer 11

The issue is the wire you ran the red wire of the P3 part #90195 to. We've heard from Tekonsha that a 1 amp diode needs to install on this circuit to prevent the controller from backfeeding onto the vehicle wiring. Or you can use the part…

view full answer...