What is the Diameter of Oil Cap Kit # RG04-250 and What Axles Does it Fit

Question

Question:

will like to know the size of this cap and what kind of thread

asked by: Scarfo

0

Expert Reply:

The Oil Cap Kit, # RG04-250, has a outside diameter of 3-3/4 inches. It is specifically designed for 10K or 12K AL-KO/Hayes oil bath axles. If you have a different axle, this is not the right cap.

expert reply by: Michael H

0

Answer 1

The #RG04-250 Threaded Cap for Oil Bath Hubs has an outside diameter of 3-3/4 inches measured at the threaded portion as shown in the photo and is designed for 10K Al/KO axles.

view full answer...

Answer 2

The hub is going to require the proper threaded cap so you do not want to force one on that has different threads so you have done good so far. Now we just need to determine if there is a cap that will fit. We have oil cap kit #RG04-250 which fits…

view full answer...

Answer 3

The outer thread diameter of the #K71-859-00 that you referenced is 3-3/4 inches so this would work for you based on what you mentioned.

view full answer...

Answer 4

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down until…

view full answer...

Answer 5

In order to locate the correct replacement oil cap kit for your trailer, I recommend taking a quick measurement of your existing cap's outer diameter. For example, the Redline Oil Cap Kit 10-12K #RG04-250 has an outside diameter of 3-3/4 inches…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

What is the Diameter of Oil Cap Kit # RG04-250 and What Axles Does it Fit

Product Page this Question was Asked From

Continue Researching