Replacement 4 Way Wiring Harness for Yacht Club Snowmobile Trailer

Question

Question:

Hello, Im trying to find a replacement wiring harness for my 2000 Yacht Club two up Snowmobile Trailer. Do you have a harness to recommend ? Thank you

asked by: Dave

0

Expert Reply:

You're on the right track! If you're wanting to install a new 4 way connector on your snowmobile trailer you can use the 35-ft 4 way Trailer Wiring Harness # A35W42B. This is a wishbone style harness that comes with the tail light wiring already split up to allow you to more easily run the wires down the sides of the trailer to the lights.

This wiring harness has 35-ft of wiring to accommodate even the longest trailers and can be trimmed down as needed to accommodate for shorter trailers.

I've linked a short review video of this harness, as well as linked a few of our help articles on wiring a new 4 way connector that you might find helpful.

expert reply by: Erik B

0

Answer 1

We have numerous trailer wiring harnesses you can use for your snowmobile trailer, but none specifically for a Triton trailer. You just need to choose from if your trailer needs a 4-way or 7-way, and there are 7-ways with insulated cable which is…

view full answer...

Answer 2

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 3

Standard 4-pole trailer wiring uses flat-style connectors, like part #W787268 which is a trailer-side connector and part #HM48044 which is the mating vehicle side connector. On these items and on the 16-gauge bonded 4-pole wire #16-4B-1 you…

view full answer...

Answer 4

For your wiring, you will need to test your wire functions to know which one connects where. I recommend using a 12v battery and simply connecting the negative terminal to the trailer frame and then connecting the power to each wire at the…

view full answer...

Answer 5

Yes you should! You are on the money with what you need, a wishbone-style 4-way wiring harness for your trailer. With this style, the white is ground, yellow is left turn/brake, green is right turn/brake, and the two brown wires are the running…

view full answer...

Answer 6

Wiring the grounds for your tail lights and the 35 ft. Wishbone 4-Way Trailer Wiring Harness with 42 inch Ground Wire, item #A35W42B, is fairly simple. The 42 inch ground wire provided with the harness is normally attached to the trailer frame near…

view full answer...

Answer 7

The gauge of wire used for all 4 wires of the 35 Ft 4-Way Trailer Wiring Harness #A35W42B that you referenced is 20 AWG.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...