Replacement Tailgate Side Hinge for 1st Generation Extang Trifecta

Question

Question:

Hi, i have a 2000 toyota tundra extended cab with 6.5ft bed. I have the first verson of the extang trifecta, i was wondering if this hinge would work on the part closest to the tailgate where the spring handle is to the middle section? Thank you

asked by: Chris

1

Helpful Expert Reply:

I've confirmed with Extang that the # EX1033 you mentioned is indeed the correct replacement hinge for the panel closest to the tailgate. It is compatible with the first generation Extang Trifecta you have.

expert reply by: Mike L

1

Answer 1

The Extang #EX1032 replacement hinge that you referenced is made for Extang Trifecta and Extang eMAX folding tonneau covers as a hinge replacement. I reached out to my contact at Extang and found out that they also make the Gator covers and that this…

view full answer...

Answer 2

I emailed Extang for tips on installing the hinge part #EX1033 and this is what they sent back: "The hinges should just slide into the rails of the cover. It is easier when the cover is folded open and you are putting both sides of the hinge in…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

You would want the whole hinge assembly, #EX1033, especially if you have frequent breakage like you have described. There could be fatigue to the other components so to ensure maximum longevity I do recommend the whole hinge assembly. It is possible…

view full answer...

Answer 7

We do have that part for you! The correct part is the Replacement Tailgate Hinge for Extang Trifecta and eMax Tonneau Covers #EX1033. This is the same part as Extang's 35440400 that you reference.

view full answer...

Answer 8

We don't offer the Gator branded tonneau covers, and parts like these aren't typically tested for compatibility across brands. With that said, I've included a diagram that gives the measurements of the #EX1033 hinge so that maybe…

view full answer...

Answer 9

Yes, the Replacement Corners with Pads #EX4211 can also fit the Lund Genesis trifold tonneau covers. To ensure that this is the correct part for your cover you can check your owners manual with the parts breakdown. You should see part 4211 as a…

view full answer...

Answer 10

We do not offer any replacement parts that directly are for your Gator tonneau cover, however Extang also made Gator covers so their tailgate hinge #EX1033 and their cab side hinge #EX1032 may work for you, however you're going to want to make…

view full answer...