Wiring Needed To Use Rampage Light Strip On 2012 Toyota Tundra

Question

Question:

what curt T connector do I need to hook up the rampage light strip on my 2012 Tundra

asked by: David G

0

Expert Reply:

The Rampage SuperBrite LED Tailgate Light Bar part # RA960134 does connect to a 4-pole flat trailer connector on the Tundra. For that I recommend Curt T-Connector Vehicle Wiring Harness for Factory Tow Package part # C55774 which will allow you to plug into the factory tow port under the bumper and gives you a 7-way plug and a 4-pole flat to plug your light strip part # RA960134 into. You can use both the 4-pole and 7-way functions at the same time as long as you don't overload the circuit which I don't see happening with the LED light bar because LEDs draw very little power. I have attached a photo of what your factory tow port under the bumper should look like.

If your Tundra happens to not have the factory 7-way tow package you can use Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # HM11141835 to power the light strip. This will plug into a square connector under the bumper.

expert reply by: Heather A

0

click to enlarge

Answer 1

Based on how you described it, I'm guessing your 2001 Ford F-350 Super Duty needs a different part than the #C55774, but what does the plug look like? The correct 7-way is going to depend on that, as the Curt option you mentioned is a replacement…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The Ford Transit if equipped with the factory tow package would have came with both a trailer hitch and trailer connector and they would both be located directly under the rear bumper so odds are you do not have either because they are not hard to…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Wiring Needed To Use Rampage Light Strip On 2012 Toyota Tundra

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching