Hopkins Custom Fit Vehicle Wiring - Trailer Hitch Wiring - HM43385 Review Video

This part comes with a mounting bracket so you can mount it wherever you need to in order to have access to it. It will plug into factory connectors and not require any hard wiring.

The picture you submitted looks like a connector for an intermediate harness for a 7-way on your 2011 Toyota Tacoma. Most likely he went to take the 7-way off of his truck and instead of just removing the connector he went further up the wiring and…

On your 2004 Toyota Tundra, there are two possible 7-way connectors that could work on your vehicle. Up under the rear of your truck there should be two plugs that you will need to plug in the 7-way. One plug will be connected to your current 4-flat…

Since you have a 4-way currently installed on your 2001 Toyota 4Runner, need a 7-way that will also retain a functional 4-way, and don't need to operate trailer brakes your best option would be the part #37185. Your 4-Way will plug into this…

There is a difference between the Tow Ready #20137 and the Hopkins #HM43385. Each trailer connector uses two plugs that insert into the factory connections, but the 3 pin plug on each is wired DIFFERENTLY. For some unknown reason, Toyota wired the…

I have included a picture for you that will help. On your 2004 Toyota Tundra, find the connector under the truck that #HM43385 would plug into. Then use a circuit tester, #PTW2993 if you do not have one, to test the pins on the 3-pin part. The pins…

Yes, the #HM11141835 that you referenced has been confirmed to fit your 2012 Toyota Tundra and would install in the connectors you have found behind the bumper. Or, if you have a factory 7-way and you want to keep it functional and have an additional…

Check out the install video I attached that shows how to use the install harness #3040-P on a very similar 2013 Toyota Tundra as yours. It will be right by the emergency brake pedal under the dash. I attached a picture that shows it as well.

The Rampage SuperBrite LED Tailgate Light Bar part #RA960134 does connect to a 4-pole flat trailer connector on the Tundra. For that I recommend Curt T-Connector Vehicle Wiring Harness for Factory Tow Package part #C55774 which will allow you to plug…

There isn't a replacement housing for the #HM43385 that you have so you'll have to replace the entire thing since yours has been damaged. It's easier than you'd think to break them while backing up for sure since they typically hang…

The part you have selected, the Hopkins Tow Package Wiring Kit for Toyota Tundra, part #HM11143395, is specified for 2008 - 2010 Toyota Tundra trucks. This part has two grey connectors to couple with the factory wiring; one is a 2-wire rectangular…

The Hopkins Plug-In Simple Vehicle Wiring Harness for Factory Tow Package part #HM11143395 has two leads that should be connected. If those are both connected then your truck was not equipped with the factory wiring in place to get the signals back…