How To Measure For A SolidStep On 2019 Heartland Pioneer RE275

Question

Question:

will solid step work on 2019 heartland pioneer re275 ?

asked by: CHUCK E

1

Helpful Expert Reply:

I am happy to recommend a SolidStep option for the 2019 heartland pioneer re275. However, I would need a couple of measurements from you first to get you the correct step. First measure the door way width frame to frame like in the photo I have attached. Then you need to measure from the bottom of the doorway to the ground for entry height. If you provide those measurements I can assist you further.

expert reply by: Heather A

1

click to enlarge

Answer 1

Thanks so much for the photos they were super helpful, and based on those we do have the exact Lippert SolidSteps you need. Since your doorway width is just over 25 inches and entry height is just over 34 inches the correct SolidStep is the…

view full answer...

Answer 2

The correct triple SolidStep will be determined by measuring your door width from frame to frame and rounding up to the nearest even number. So for a door width of 24-7/8 inches, you were correct in your initial assessment; the steps you need are the…

view full answer...

Answer 3

The SolidStep Manual Fold-Down Steps are an extremely universal RV step option. However, you will still need to measure the RV's doorway to determine fitment. If the RV's doorway measures 26" to 29-7/8" wide then you will want to…

view full answer...

Answer 4

To pick out Lippert SolidSteps for your RV you need to measure the opening width for the door and then the height from the ground to the threshold of the door so we can get you the correct amount of steps. Aside from that these would fit well on a…

view full answer...

Answer 5

The SolidStep Manual Fold-Down Steps part #LC791572 will fit a door way from 25" -28.9" wide when measuring the frame inside. If the factory label sticker shows a doorway width between 26"-29" then the above steps will work for…

view full answer...

Answer 6

In terms of choosing a Lippert Solid Step, you'll use the width of the finished door at it's narrowest. Round that number up to the next full inch, which in your case would be 28 inches. In that case, you'll want the adjustable model…

view full answer...

Answer 7

Yes, the #TLD2142 is exactly what you need for your 2019 Ram 3500 with running boards extending under the truck bed. For the rear, you need the #TLD3112 if you have the factory hitch or #TLR3510 if you have the TorkLift SuperHitch Magnum 30K.

view full answer...

Answer 8

We've seen this issue before on an older camper that had the screen door installed a little lower than how they are now. An installer here actually had this exact problem. If your door is close to closing, a couple suggestions that you can try…

view full answer...

Answer 9

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 10

The MORryde StepAbove RV Steps #MR85RR weighs about 70 lbs. As far as the flip step, I assume you are referring to the MORryde Flip Tread RV Steps #MR42UR which weighs about 45 lbs. Both of these steps will fit your 28" wide door. Personally I…

view full answer...

Answer 11

I recommend Advent Air RV Air Conditioner part #ACM135C for the 8.5x24 ft enclosed trailer. The temperature range is 65 degrees F to 90 degrees F so it will keep your enclosed trailer nice and cool on hot days. You can also add a heat strip with part…

view full answer...