Fan Motor Replacement for Philips Bathroom Vent V2044

Question

Question:

I need a fan motor for a Philips fan light V2044. On your website you mention two different motors that would work. Not sure which one? Should I use: BCD0390-00 or BCD0314-00??

asked by: Sean W

0

Expert Reply:

The correct replacement motor you need for the Philips/Ventline RV vent part number V2044 is the part # BCD0390-00 that you mentioned. We've confirmed this as the correct fit. The # BCD0314-00 fits the 75 CFM versions of the vent like you have whereas the part # BCD0390-00 fits the 100 CFM versions.

expert reply by: Jameson C

0

Answer 1

The Ventline V2044 Bathroom Ceiling Vent can use the Replacement 110-Volt AC Fan Motor for Ventline RV Bathroom Insert Fan w/100 CFM Capacity #BCD0314-00 or the Replacement Fan Motor for Ventline Exhaust Fan #BCD0390-00. We have confirmed with…

view full answer...

Answer 2

The correct replacement motor for your Ventline V2262-50 bathroom fan is the part #BCD0388-00 and it's held on with a couple nuts on top of the support beam like you see in the attached picture. To access the fasteners to remove the beam…

view full answer...

Answer 3

The correct replacement motor for your Ventline V2262-50 bathroom fan is actually the part #BCD0388-00. This will work perfectly with your existing fan as it is a direct replacement. The #BCD0390-00 Replacement Motor that you mentioned is designed…

view full answer...

Answer 4

It sounds like the #BCD0314-00 will work for you. The shaft's diameter is 3/16 inches and the entire length from tip of the shaft to the end where the mounting screws go through is 3-1/2 inches. Also the shaft itself is 1-3/8 inches long.

view full answer...

Answer 5

We definitely have replacements for your Ventline 2262-50 motor and fan blade. With that being said, the Replacement 110-Volt AC Fan Motor for Ventline RV Bathroom Insert Fan with 50 CFM Capacity #BCD0388-00 will be a direct replacement. There does…

view full answer...

Answer 6

The correct fan for the motor #BCD0390-00 is going to be the #BCD0311-00, which is a 5-5/8" diameter blade.

view full answer...

Answer 7

Some versions of the Ventline fan V2265 have the plug that part #BCD0390-00 connects right into. Not all of them do and you can cut the connector off and hardwire it in. Or we also carry part #BCD0390-01 and hardwire it. The motors are the same.…

view full answer...

Answer 8

I spoke to my contact at Ventline and they informed me that if your Ventline Fan Model 2044 has a 100 CFM motor then you would need to use part #BCD0314-00 but if it has a 75 CFM motor then you will need to use part #BCD0390-01. If you are unsure…

view full answer...

Answer 9

Replacement 110-Volt AC Fan Motor #BCD0390-01 is the motor for Ventline Roof Vent #V2128SP-01. The motor you need for your Ventline #V2044 is #BCD0314-00 if you have the 100 CFM model or #BCD0390-01 if you have the 75 CFM model.

view full answer...

Answer 10

The motor you sent in a picture of is very similar to the #BCD0314-00 but it is slightly different than the part #BCD0314-00 when comparing the two. It appears as this motor will work just fine as a replacement though. Basically either wire can be…

view full answer...

Answer 11

For a replacement motor for your Ventline V2062 you'd need #BCD0314-00 which also fits as a replacement for the V2262.

view full answer...

Answer 12

We've checked with Ventline in the past and we do have a replacement motor for the Ventline V2062 with the part #BCD0314-00.

view full answer...

Fan Motor Replacement for Philips Bathroom Vent V2044

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching