Distance From Center of Shaft Down to Bottom of Bulldog Powered Drive Kit BD1824200100

Question

Question:

I would like to know the dimension from the center of the shaft of the bottom of the gearbox.

asked by: James

0

Expert Reply:

From the center of the shaft of the Bulldog Powered Drive Kit part # BD1824200100 that you referenced down to the bottom of the gear box measures 5-3/4 inches.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The wiring for the Bulldog Powered-Drive Kit #BD1824200100 is as follows for the four wires in the wiring harness. The Black wire from the battery goes to the Black wire on the harness The Red wire from the battery goes to the Red wire on the harness…

view full answer...

Answer 2

I called my contact at the manufacturer and the dimensions of the motor are 3-9/16 inches wide, 6-3/16 inches wide and 8 inches long. It might be too sung of a fit. However, depending on your jack setup, if it is bolted you may be able to add a…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 8

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 9

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 10

Your typical electric jack is designed to fit an A-frame so the only one we carry that is a side mount is the Fulton XLT #F141401. However, you may be interested in the Trailer Valet JXS Drill Powered Swivel Trailer Jack #TV64FR. This jack has a hand…

view full answer...