Can the Gear Box on the Landing Gear Set RVLG-8000 Be Turned

Question

Question:

Can the manual crank plate be rotated on the leg for a side orientation?

asked by: Carlos M

0

Expert Reply:

The gearbox on the Landing Gear Set part # RVLG-8000 can be rotated 90 degrees so that the drive shaft is positioned in front of the leg. That said, you will need to make sure you have adequate clearance to make a full rotation on the handle. The actual handle is not included either so if you don't have one you will also need the Replacement Crank Handle part # RVLG-HDL.

expert reply by: Conner L

0

Answer 1

The Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear #RVLG-HDL measures 31" long, including the handle on the end. The crank assembly itself measures 27" not including the handle on the end. I attached a photo diagram…

view full answer...

Answer 2

Turning the wheel so that the teeth on the wheel move upward will expand the brake shoes against the inside of the brake drums. Moving the teeth downward will contract the brake shoes. You can see the adjustment procedure by clicking on the video…

view full answer...

Answer 3

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 4

I'd be happy to help you out, John! To replace the brakes on your 5th wheel trailer you need the etrailer Electric Trailer Brakes #AKEBRK-7-SA which come with a self-adjusting feature so once you initially set them up you won't have to adjust…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…

view full answer...

Answer 8

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

view full answer...

Answer 9

Are there any visible signs of wear on the magnets like exposed windings then that would indicate they need replacing. Magnets can go bad without showing visible signs of wear though. To see how to troubleshoot them check out the help article I…

view full answer...

Can the Gear Box on the Landing Gear Set RVLG-8000 Be Turned

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching