Recommended Side Mount Trailer Jack for Log Splitter Trailer

Question

Question:

Looking for a side mount trailer jack with 8inch retracted length, with a 4-5inch wheel, for use on a light weight log splitter application.

asked by: Peter

0

Expert Reply:

I do have some options for you but I am not sure you are going to find a trailer jack with all of the exact features you are looking for. The minimum lift we offer is 10" and all of the caster wheels are 6" diameter. If you can make these two things work then we have plenty of options which I have attached a list of for you like the Round Swivel Marine Jack w/ Wheel part # MJ-1206B.

expert reply by: Conner L

0

Answer 1

The issue is that there is a screw inside the jack that turns in either direct to raise or lower the jack. It threads through a fixed nut. At the very top of the screw the threads are all mashed up so that the leg can't just fall out. Basically…

view full answer...

Answer 2

I do have an option for you but the Curt Trailer Hitch Receiver part #13390 on your 2015 Subaru Legacy already has the highest ground clearance (10-1/4") of any other trailer hitch receiver we have confirmed to fit your vehicle. This measurement…

view full answer...

Answer 3

While it is certainly a good idea to carry a second spare tire on your trailer we do not recommend mounting two of the Fulton Hi-Mount Spare Tire Carriers #FSTC1000301 back to back. Apart from the need for some stronger (and unknown) grade of…

view full answer...

Answer 4

The Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc part #MJ-1206B is designed with a Corrosion-resistant clear zinc finish so it should not rust unless it is submerged for long periods of time or used for prolonged periods of time in salt water…

view full answer...

Answer 5

In order to get a ball mount that has effectively 0 inches of rise or drop you would need to get a Trailer Hitch Ball Mount, part #D-4, like the one you referenced that has a 2 inch drop, and then use a 2 Inch High Rise Ball, part #C40034. I attached…

view full answer...

Answer 6

The spare tire carrier for E-Tracks, #RA-16HST, would hold and secure a spare outside of a trailer but it would not be ideal. The issue is that there will be some movement of the tire since the E-Track connection is not tight. It is secure, but there…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Recommended Side Mount Trailer Jack for Log Splitter Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching