Should Trailer Brakes Be Able to Lock Up When Override Lever of Controller is Slid
Question:
I have a brand new 2019 outlaw car hauler 3500 lb axles brakes on rear only, if I have the brake controller all the way up and the trailer is empty should the brakes lock up if I hit the override switch? Mine will not. The shoes have been inspected and adjusted properly, the dealer I bought the trailer from none of the new trailers would lock up... that is the way Ive always tested my brakes but maybe Im wrong. The wire coming from the plug is very small like 18 gauge and is connected by a cheap blue wire splice on both sides, is that sufficient to power the brakes? Thank you,
asked by: Tony H
Helpful Expert Reply:
The issue is that the gauge wire you have for the brake output circuit is too thin. You need to be using 10 gauge wire like part # 10-1-1 (sold by foot) to deliver the needed amperage and voltage for the brakes to apply. They should easily lock up with the trailer loaded or unloaded.
Products Referenced in This Question
Product Page this Question was Asked From
Dexter Electric Brake Assembly for 4 Bolt or 5 Bolt Flange - 12" - Left Hand - 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 6000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- Dexter
more information >
Continue Researching
- Shop: Dexter Trailer Hub and Drum Assembly for 4,000-lb E-Z Lube Axles - 10" Diameter - 5 on 4-1/2
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Front Mount Hitch
- Video: Curt Front Mount Trailer Hitch Installation - 2015 Ram 2500
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Q&A: Voltage at Brake Magnets is 8 Volts with Brake Controller Set to Maximum
- Article: Troubleshooting Brake Controller Installations
- Q&A: Self-Adjusting Brakes Will Not Lock Up Trailer After Fresh Install
- Q&A: Dexter Never Adjust Brakes Initial Adjustment on Tandem Axle Trialer
- Shop: Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Shop: Bargman 7-Way, RV-Style Connector w/ 10' Heavy Duty Insulated Cable - Trailer End
- Video: Dexter Nev-R-Adjust Electric Trailer Brake Kit Installation
- Q&A: Correct Replacement Hubs/Drums and Brakes for a Dexter 4,000 Lb Axle
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: What is the Best Way to Jack Up a Boat Trailer with Torsion Axles
- Q&A: Testing for Proper Voltage on the Brake Output Circuit
- Shop: Hopkins 7-Way Molded Trailer Wire Connector - 11' Long
- Shop: 7-Way Molded Trailer Wire Connector, 4' Long
- Search Results: brake mounting plate
- Video: Review of Dexter Axle Trailer Brakes - Electric Brake Assembly - 23-105-09
- Video: Dexter Electric Brake Assembly Review
- Shop: Trailer Hitch
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 68149
- Video: Choosing the Right Brake Controller
- Shop: Trailer Wiring
- Shop: Brake Controller