Dimensions of U-Bolts Included with Malone MPG561 Kayak Trailer Bunk Kit  

To add bunks, you will need the bunks, brackets, and u-bolts. Bunks - CE Smith Carpeted Bunk Boards #CE27845 Brackets - CE Smith Bolster and Swivel Bracket Assemblies #CE10000G-4 U-bolts - CE Smith U-Bolts #CE15283GA-4 This is typically done on…

The U-Bolts that arrive with the Malone Crossbar Conversion Kit #MPG475 Hardware Kit are 1/2" U-Bolts that 6" long & 2" wide.

The Malone TopTier Load Bar Kit for Utility Trailers part #MPG493 fits 4' wide and 5' wide trailer decks so it would not be compatible with your 6 foot wide utility trailer. The Malone Crossbar Conversion Kit for Standard…

The Malone MicroSport trailers like you have use the bearing kit part #BK1-100 that you mentioned which comes with the correct seal size. Or for a replacement hub that comes pre-greased part #34822545BX. Then for a heavy duty and waterproof grease…

On the Malone MicroSport Trailer #MPG460G the overall width side to side is 65 inches because the crossbars are the widest part of it. The trailer itself is about 55 inches wide if the bars were taking off. The overall length without an extension…

Yes, to carry your 2 kayaks you will need to add 2 of the Bunk Kit for Malone Trailers #MPG561 to the Malone 2 Tier LowBed MicroSport Trailer #MPG464-LBT. The bottom cross bars are 78" long and are the widest points for the trailer. From…

The Bunk Kit for Malone Trailers #MPG561 is designed to fit the 1-1/4" Crossbars #MPG4001 currently used on Malone trailers. You can still use them with your crossbars but will need to account for the difference in size with some flat…

Yes, the Bunk Kit #MPG561 that you referenced will fit and work perfectly on the Malone MicroSport trailer as we have confirmed this with Malone in the past that it fits your trailer and it's crossbar size.

We can piece together a Malone Lowbed trailer by first starting with the part #MPG464-LB and then a single bunk kit part #MPG561 and then the spare kit part #MPG465 and you'd be set. There isn't a kit with just the parts you are…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is…