Length, Width, and Height of Malone MicroSport Trailer Using Retractable Tongue Kit

Question

Question:

Looking to buy the trailer and retractable tounge but need to know the depth of trailer when stored against the wall

asked by: Delta B

0

Expert Reply:

On the Malone MicroSport Trailer # MPG460G the overall width side to side is 65 inches because the crossbars are the widest part of it. The trailer itself is about 55 inches wide if the bars were taking off. The overall length without an extension is 14 feet but that can be adjusted to be shorter using the retractable tongue kit you mentioned # MPG494. The overall height to the top of a crossbar is 30-1/2 inches.

The tongue by itself is 8 feet long. The use of the retractable kit reduces the trailer overall length by 61 inches so the overall length after installing the retractable tongue kit, and retracting the tongue, will be about 107 inches or about 9 feet.

expert reply by: Michael H

0

Answer 1

While installing a trailer hitch can cause some interference of the hands-free liftgate function for your 2017 Platinum Toyota RAV4, it can definitely still work. The hitch mounting location can mean that only the centrally-positioned sensor will…

view full answer...

Answer 2

We do have hitches that fit the 2021 Toyota Rav4 Prime. I recommend the Curt Trailer Hitch Receiver part #C13416 which is a direct bolt-on fit. It is very easy to install and provides the larger 2" receiver tube so you'll have a…

view full answer...

Answer 3

The Storage Trunk #MPG481 will not work with the LowBed MicroSport #MAL25FR as the bunks sit too low on the trailer. Instead you will want the Malone MicroSport Trailer #MPG461B2 or if you already have the LowBed you can use the Crossbar Conversion…

view full answer...

Answer 4

The Malone MicroSport Trailer #MPG460G does have the 1.98 inch inner diameter hub. I confirmed this with the manufacturer. To add bearing buddies, you simply need the #BB1980A for chrome or #BB1980A-SS for stainless steel. You will not need to…

view full answer...

Answer 5

Yes, the Malone MicroSport to LowBed Trailer Conversion Support Tubes #MAL33TR will allow you to transform your MicroSport Trailer #MPG461B2 into the LowBed #MAL25FR. This will make it much easier to load your kayaks or possibly we launch them…

view full answer...

Answer 6

In order to swap your surge brakes to electric over hydraulic, you're going to need to change out your actuator and add a proper brake controller. For an actuator I'd recommend going with the Hydrastar Electric Over Hydraulic Actuator for…

view full answer...

Answer 7

The VIN sticker that comes with the Malone trailers like the Microsport part #MPG460G is supposed to be applied up near the coupler of the trailer on the frame. It comes as a separate decal though so it's up to you where to put it.

view full answer...

Answer 8

Yes, if you install the #MAL33TR on your Malone Microsport you'd still have the same amount of bar space to carry the same amount of kayaks as you did before. This keeps the bars still above the fenders of the trailer so you don't lose any…

view full answer...

Answer 9

The Retractable Tongue Kit for Malone MicroSport Trailers #MPG494 is designed to replace a damaged tongue on a MicroSportXT #MPG460XT, or to upgrade the tongue on a Malone MicroSport Trailer #MPG460G. Both of these trailers have an overall length of…

view full answer...

Answer 10

The Malone MicroSport trailers like you have use the bearing kit part #BK1-100 that you mentioned which comes with the correct seal size. Or for a replacement hub that comes pre-greased part #34822545BX. Then for a heavy duty and waterproof grease…

view full answer...

Length, Width, and Height of Malone MicroSport Trailer Using Retractable Tongue Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching