Installation of Furrion RV Outdoor Receptacle Cover

Question

Question:

How does it get mounted? Is the foam glued on or does the whole unit screw on? thank you,

asked by: David J

0

Expert Reply:

The Furrion RV Outdoor Receptacle Cover - 15 Amp - Black # F15RCSBSAM does simply screw into place. It has holes that need to be drilled out and these will allow you to screw it in.

This cover also comes in White # F15RCSPSAM.

expert reply by: Kyle S

0

Answer 1

The Furrion RV Outdoor Receptacle Cover #F15RCSBSAM referenced in your question will fit current style GFCI rectangular outlets with screws at each end. The cover features a waterproof construction and a spring-loaded lid that will protect the…

view full answer...

Answer 2

I pulled this speaker from inventory to take a picture and measurements. The diameter at the outside edge of the grill is 5-9/16". The mounting hole diameter is 4-7/16" The center of the screw holes are inset 1/4", so the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 8

The Curt #C13410 and Draw-tite #76227 are very similar in design and both have the same weight ratings of 600lbs tongue weight and 4,000lbs of trailer weight. I do like that Draw-Tite does add the additional plate of steel in between the hangers that…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

It appears the wiring to connect a Trailer Brake Controller #90195 on your 2024 GMC Yukon are going to be high up on your dash close to the left side of the drivers compartment. You can start by removing the left side panel of the dash which sits up…

view full answer...

Answer 11

The foam panel is in the bumper to help support the bumper panel as well as provide a cushion for the cover if there is a minor collision. Without the cushion the cover will tend to break or crack easier as it does not have the support needed. I have…

view full answer...

Answer 12

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

view full answer...