Troubleshooting Difficult to Lower Exhaust of 2012 Ford Mustang for Hitch Install
Question:
Hello, I have a 2012 Mustang V6 Premium and I have hitch #24863. I have removed the rear rubber exhaust hangars and have loosened the strap bolts. However, my mufflers will not rotate downward at all. I have the strap bolts very loose and I tried WD40 and tapping it with a hammer in case there is rust. Do you have any advice?
asked by: Paul
Expert Reply:
Exhaust components can be pretty stubborn, but you have done everything correct so far. Once you loosen the straps and remove the exhaust hangers the pipes should be able to pivot down. I'd try letting the WD40 sit for a while and try again. Eventually the hanger should break free and allow the pipe to pivot. Also make sure you have the strap as loose as possible as even some tension can prevent the pieces from pivoting.
I attached an install video that shows how this is done near the beginning as well.
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Swagman Trailhead Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Tilting
- Search Results: hitch bike racks
- Video: Trailer Hitch Installation - 2014 Ford Mustang - Draw-Tite
- Video: Trailer Hitch Installation - 2013 Ford Mustang - Draw-Tite
- Video: Trailer Hitch Installation - 2011 Ford Mustang - Draw-Tite
- Video: Swagman Trailhead 4 Bike Rack Review s63365
- Shop: Curt 2 Bike Platform Rack for Fat Bikes - 1-1/4" and 2" Hitches - Frame Mount - Tilting
- Shop: Curt 2 Bike Platform Rack - 1-1/4" and 2" Hitches - Frame Mount - Tilting
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Hollywood Racks Destination Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Shop: Floor Mats
- Shop: Vehicle Seat Covers
- Q&A: Will Draw-Tite Class I 1-1/4 Inch Hitch # 24863 Fit A 2011 Ford Mustang Convertible
- Q&A: Will the ThuleOutWay Platform Bike Rack # TH65JV Fit on a 2011 Mustang with Satellite Antenna
- Video: Hollywood Racks Hitch Bike Racks Review - 2020 Toyota RAV4 HLY94FR
- Video: Hollywood Racks Hitch Bike Racks Review - 2022 Hyundai Santa Cruz HLY94FR
- Video: Hollywood Racks Hitch Bike Racks Review - 2015 Hyundai Elantra
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: 44649
- Shop: Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 68149
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Brake Controller
- Search Results: dust cap
- Shop: Fifth Wheel Hitch