Installing Upper Brackets for Solera Family Room # LC362233

Question

Question:

do you attach the 2 upper brackets so they sit flush with the trailer or are the angled

asked by: Chantal

0

Expert Reply:

I'm not quite sure what you mean by attaching the upper brackets at an angle for the Solera Family Room # LC362233, but when the 2 brackets are installed they should sit directly under the awning rail so that the hook is just about 2 inches under the awning fabric. I have attached an image from the installation instructions that show the bracket attached to clarify.

Please let me know if this does not answer your question completely or something else comes up and I will be happy to look into this further.

expert reply by: Chris R

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 3

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 4

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 5

Yes, if you plan on bolting the Stromberg Carlson Adjustable Accessory Hitch Receiver #SC45MR on then you would need to drill holes in the adjustable arms in order to set them to the correct length. There aren't any predrilled so that this one…

view full answer...

Answer 6

You will need the Ceiling Garnish for Fan-Tastic Vents Roof Vent #FVK1060-81 as it is specific to your Dometic Fantastic Fan 1450. The Ceiling Garnish for Ventline Roof Vent #VA0445-37 is going to have rounded corners as opposed to the square on the…

view full answer...

Answer 7

You'd need a new panel like the Progressive Dynamics Mighty Mini part #PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible. There isn't a center section replacement available for what you have that…

view full answer...

Answer 8

To replace your WFCO WF-8750P power center I recommend the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K. This 2-in-1 AC/DC distribution panel and converter charger keeps your power systems easily…

view full answer...

Answer 9

The center to center measurement of the mounting bracket bolt-holes for the Stromberg Carlson Adjustable Accessory Hitch Receiver #SC45MR is 5-7/8". Additionally, there are two other bolts holes on the angle brackets that measure 3-1/8"…

view full answer...

Answer 10

I do say those welds are bad and it appears the bumper is simply welded onto the back plate of the trailer rather than the frame. I recommend removing the entire bumper for the Mount-n-Lock Heavy-Haul'r Replacement RV Bumper #MNT43VR which you…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Installing Upper Brackets for Solera Family Room # LC362233

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching