Gearbox Replacement for 2011 Keystone Montana 3150

Question

Question:

Do you have a replacement part to match the oem part for the aforementioned 5th wheel? The motor seems to be ok. Can the reduction box be replaced with one of your products?

asked by: Randy L

0

Expert Reply:

Lippert made specific replacement landing gear for your 2011 Keystone Montana 5th Wheel. That means that for a replacement gear box you need the # LG-179015 and you'd be set!

expert reply by: Jameson C

0

Answer 1

I attached a picture that has a wiring diagram for the Ultra Fab Landing Gear part #UF17-943010 that you referenced. I also attached a link to the install instructions for this jack as well.

view full answer...

Answer 2

In order to pick out a direct replacement for the landing gear on your Challenger RV we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and…

view full answer...

Answer 3

It sounds like you need a replacement gearbox. For a Venture replacment, that is aluminum instead of plastic, part #LC276602 is what you're looking for.

view full answer...

Answer 4

Take the top off of the jack leg and inspect the bevel gears that you can see. If they look damaged all you'd need is the repair kit part #LC146060. If other components look damaged it would be best to replace the entire leg with part…

view full answer...

Answer 5

In order to determine if the issue you are having with your landing gear legs clicking and popping is caused by the gear box or leg assembly you will simply need to disconnect the gear box from the legs and then test each manually. If you feel…

view full answer...

Answer 6

The Stromberg Carlson Electric Landing Gear Set #LG-4 will work with your 2004 5th Wheel KZ New Vision Ultra per the vendor. This system is perfect for raising, leveling, and supporting your 5th-wheel trailer or RV. The direct-drive motor will reduce…

view full answer...

Answer 7

Most of the landing gear sets will use the same bracket height dimensions for the install of a new landing gear set. Check out the picture I attached that shows the dimensions of the brackets for the Ultra Fab landing gear for you to compare to your…

view full answer...

Answer 8

Any powered landing gear or powered tongue jack will draw less power as it legs descend down toward the ground and much more as soon as they make contact and encounter resistance. This is a normal occurrence. In the same way, any jack - even a manual…

view full answer...

Answer 9

The square tube on the Ultra-Fab Deluxe Electric Landing Gear Set, #UF17-943010, measures 2-1/2 inches x 2-1/2 inches and it measures 24-1/4 inches tall. The foot plate measures 8 inches long x 5-3/4 inches wide. I have attached a photo showing these…

view full answer...

Answer 10

We have exactly what you would need. For a gooseneck trailer you would need a powered landing gear set like the Ultra-Fab Deluxe Electric Landing Gear Set #UF17-943010. This dual motor set has 12,000 lbs of lifting capacity and would work very well…

view full answer...

Answer 11

If the Lippert landing gear on your trailer is operating in reverse (up is down and down is up) then most likely something is miswired between the switch and motor. Check to make sure that the connections are correct for these 2 wires in particular.…

view full answer...

Answer 12

Essentially the #LG-196308 and the #LC196308 are identical. I'd go with the lower priced of the two since neither is a better choice than the other.

view full answer...

Gearbox Replacement for 2011 Keystone Montana 3150

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching