How to Pick Out Landing Gear for a 2003 Keystone Challenger RV
Question:
Which following jack do I purchase for the landing gear on my Challenger RV?
asked by: Warren B
Expert Reply:
In order to pick out a direct replacement for the landing gear on your Challenger RV we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Ultra Fab Landing Gear. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # UF17-943010.
I attached a picture that shows the dimensions that this landing gear set would fit with.
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Correct Replacement for Atwood 71119 Landing Gear Motor
- Q&A: Diameter of Replacement Hinge Pin # 362TRCHingePin2
- Q&A: Atwood 87701 landing gear switch replacement
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Recommendation for Replacing Bevel Gears for Atwood Landing Gear or Replacing Entire Landing Gear
- Q&A: What Does Code L. Mean on Curt Triflex Brake Controller
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How Much Solar Power Do I Need For My RV?
- Article: Does Solar Panel Type Really Matter?
- Article: Trailer Tire Sizing