Head Replacement for Equal-i-zer Weight Distribution # EQ37041ET

Question

Question:

Can you purchase just the 3 pcs that hold the bar

asked by: Joseph H

0

Expert Reply:

Sounds like you are looking for just the head assembly of the Equal-i-zer weight distribution system # EQ37041ET. For that you'd just need the part # EQ90-02-0400 and you'd be set.

expert reply by: Jameson C

0

Answer 1

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 2

Yes, you should install the MORryde X-Factor Crossmembers along with the Roadmaster Comfort Ride Leaf Spring Suspension Kit #RM-2460-2580 on your Grand Design Solitude 390RKR. You will need to check to see if you will be able to use the standard…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 4

You definitely can use a fixed 5th wheel hitch for the puck system on your short bed 2024 GMC Sierra 2500 as long as you're towing a newer-style 5th wheel that has the tapered nose. We typically recommend the sliding hitch because it just…

view full answer...

Answer 5

Based on the capacities you mentioned of your 2021 Chevrolet Silverado 2500HD with the 6.6L engine you will not be over loading as you have a towing capacity of 18500lbs and your trailer only comes in at 13500lbs max. You will likely have some…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

If the rear end of your vehicle sags significantly when the trailer is hooked up then you could have an unsafe condition and your front end and tires will not wear properly. The weight is taken off of the front wheels of the vehicle and can cause…

view full answer...

Answer 8

Your camper is not too light for a weight distribution system and the Reese Pro Round Bar Weight Distribution item #RE34FR will work on your trailer. This system works with trailer's that have a tongue weight between 200 lbs and 600 lbs.…

view full answer...

Answer 9

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. Measuring is not required if you just take a look at your coupler and see where it attaches to…

view full answer...

Answer 10

A 2016 Forest River Flagstaff Hard Side T21DMHW has a GVWR of 3,382lbs so you'd be looking at a tongue weight around 300-400lbs. If you're experiencing some sway while towing your trailer then I recommend the Fastway e2 Weight…

view full answer...

Answer 11

The benefits of an Equal-I-zer hitch over the e2 is primarily the improved 4-point sway control of the Equal-I-zer. The 4-point sway control utilizes steel on steel friction at the arms as well as in the hitch head to stop sway. The e2's…

view full answer...

Answer 12

I would be happy to! Weight distribution systems are selected based off of tongue weight which is typically between 10% - 15% of your trailer's total weight. This would put yours between 250 lbs - 375 lbs. There's really only a couple…

view full answer...