Installation of Jensen Antenna for Gulfstream Vintage Cruiser 17RWD Fiberglass Travel Trailer

Question

Question:

The AN519 Jensen antenna will be attached to the side of a Gulfstream Vintage Cruiser 17RWD travel trailer with fiberglass sides. Will the supplied rubber washer for the AN519 antenna be sufficient for weather proof installation or should caulk be used instead? If it can be used, does the smooth side of the rubber washer go against the antenna base or the side of the travel trailer?

asked by: Kenneth J

0

Expert Reply:

The Jensen Antenna - Rooftop or Side Mount # AN519 comes with the mounting hardware and the seal. I recommend using Loctite RTV 598 High-Performance Silicone Gasket Maker - Black - 2.7-Fl Oz Tube # LT37467 to ensure you don't have any moisture entering at the mounting hole locations. It is not required by the manufacturer, but better safe and plan for extreme moisture than have to deal with water damage should a seal fail.

expert reply by: Jason S

0

Answer 1

The Jensen Marine Antenna part #1181067 is made specifically for boats so that is what I would use instead of the Jensen Antenna part #AN519. The marine version has a coating to protect it from the elements and there is not a separate ground wire…

view full answer...

Answer 2

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 3

Great question. They are virtually the same wireless compressor. The only difference is that the #AL74000EZ is Bluetooth compatible and also comes with a wireless remote. The #AL58WQ does not include a remote and can only be operated via Bluetooth…

view full answer...

Answer 4

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

After speaking with out expert install team I would NOT recommend patching or replacing only part of the membrane. It will just set you up for future leaks and other problems where the seam will be. Since you will have to remove the trim around the…

view full answer...

Answer 7

The maker of your trailer is really the only reliable source for its specifications and capacities. In my research on the Wells Cargo website I too was unable to find any roof details about your trailer other than that the aluminum roof on the 6 x…

view full answer...

Answer 8

The distance you'll be measuring for fitment of the Fastway ONEstep Wheel Chocks is where the chocks will actually be installed as you can see in the attached photo. If that distance is between 16" - 24" then use part…

view full answer...

Answer 9

The Optronics light you referenced in your question, part #RVSTB60 , is a 3-wire design that includes a wired ground (the white wire) rather than a mounting stud ground as found on some similar lights. The green wire is for the tail light circuit…

view full answer...

Answer 10

The MaxxAir Mini Deluxe Trailer Roof Vent part #MA00-03851 will fit the same size opening as the Fan-Tastic Vent Roof Vent that you have now but you will need to use the included garnish that is supplied with the unit that way everything lines up…

view full answer...