Dimensions of Dutton-Lainson Extra Offset Spare Tire Carrier # DL22145

Question

Question:

What is the length of the arm that goes from the mounting bracket for the trailer frame to the round plate where the tire mounts thankyou for your attention to this matter

asked by: Gerry L

1

Helpful Expert Reply:

I attached a picture of the Dutton-Lainson Extra Offset Spare Tire Carrier # DL22145 that you referenced that has all of the dimensions you asked for.

expert reply by: Jameson C

1

click to enlarge

Answer 1

I pulled a Dutton-Lainson Extra Offset Trailer Spare Tire Carrier #DL22145 to measure for you. Check out the picture I attached that shows the dimensions. From the trailer frame surface to the closest portion of the mounting flange will be 7-1/2…

view full answer...

Answer 2

I went out to the warehouse and pulled an Extra Offset Trailer Spare Tire Carrier, #DL22145, to measure. Using an angle finder, I determined that the stem is angled up 20 degrees and the surface where the spare would mount is angled down 65 degrees.…

view full answer...

Answer 3

Past customers have told us the AL-KO 8460 uses inner bearing 25580 and outer bearing 15123, which would make the Timken Bearing Kit #TMK82VR the correct replacement bearing kit for that hub. If you are looking to replace the hub entirely the correct…

view full answer...

Answer 4

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

view full answer...

Answer 5

The Kenda 4.80-12 Bias Trailer Tire with 12" Galvanized Wheel - 5 on 4-1/2 - Load Range B #AM30590 matches all of your criteria and is my recommendation for you. For your spare carrier, I recommend the Extra Offset Trailer Spare Tire Carrier by…

view full answer...

Answer 6

The spare tire can be mounted near the wheel and axle to the frame, but you will want more than 5 inches of ground clearance. I recommend the Extra Offset Trailer Spare Tire Carrier by Dutton-Lainson #DL22145 based on your photo. Every extra inch…

view full answer...

Answer 7

Most of the winches in the 2,500 lb. category are going to use the same type of handle. There are always exceptions but most use a common size. For your situation I recommend the 9-1/2" Long Winch Offset Replacement Handle by Dutton-Lainson part…

view full answer...

Answer 8

I took a look at the online owner's manual for your 2016 Toyota Highlander and found that without the towing package, your V6 model will have a trailer towing capacity of 2,000 pounds. As you mentioned in your question, this jumps up to 5,000…

view full answer...

Dimensions of Dutton-Lainson Extra Offset Spare Tire Carrier # DL22145

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching