Gear Repair Kits for Venture Landing Gear Legs on 2007 Keystone Cougar

Question

Question:

Will this gear repair kit work for a 2007 Keystone Cougar with Venture landing gear?

asked by: Robert B

0

Expert Reply:

Yes, the Follow Jack Repair Kit # LG-146060 that you referenced does work with the Venture landing gear leg you have on your 2007 Keystone Cougar. This is a repair kit for the follower leg. If instead you need a kit for a lead leg you'd want the part # LC146059.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I attached a link to a page that has all of the custom fit Reese and B and W rail kit/hitches that fit your 2013 Chevy Silverado 2500 Denali short bed. There are no fit exclusions for the Denali models and we've had customers come back and tell…

view full answer...

Answer 2

It definitely sounds like the internal gears on your existing landing gear system are shot so a complete replacement is your best option. I'm not able to track down what specific model system would have been installed at the factory on your 2004…

view full answer...

Answer 3

The Lippert Components Lead Leg Repair Kit #LC146059 and the Stromberg Carlson Kit #LG-146059 referenced in your question are essentially the same kit. I went out to our warehouse to verify this. It is actually not too uncommon for landing gear…

view full answer...

Answer 4

To add a 100 lb tank to your two tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the pigtail…

view full answer...

Answer 5

To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions for the entire kit for the replacement gear and shaft kit for your Venture landing gear leg. The instructions…

view full answer...

Answer 6

Thanks for the photo as well as the description you offered. The Follow Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146060 is the correct fit for your 2010 Coachmen Brookstone 341RE.

view full answer...

Answer 7

Actually on brake magnets for trailers either wire can be used as the power or the ground so the colors don't really mean anything. Most likely the magnet manufacturer just put what ever color was most convenient on your trailer.

view full answer...

Answer 8

I went to our warehouse and measured one of the part #C16902 pins for you. I have attached a photo that has the dimension you were asking about. As the photo denotes, the useable length on the pin is 3.56 inches. You might want to measure the pin you…

view full answer...

Answer 9

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

view full answer...

Answer 10

I recommend a 12 volt car battery rather than a breakaway battery because you may end up needing the larger battery down the road. What you will do is attach a battery box (see link for options) to the trailer frame. From the trailer side 7-Way…

view full answer...

Answer 11

You should need repair kit #LG-146059 for the lead leg and #LG-146060 for the follower leg. From the picture you sent in I was able to determine that you have a Venture landing gear set VMC900R.

view full answer...

Gear Repair Kits for Venture Landing Gear Legs on 2007 Keystone Cougar

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching