Useable Length Of Replacement Rail Pins For 5th Wheel Trailer Hitch
Question:
are these pins any longer than the ones that came with my reese. mine are just a hair short and its always a struggle to get them clipped
asked by: Mike R
0
Expert Reply:
I went to our warehouse and measured one of the part # C16902 pins for you. I have attached a photo that has the dimension you were asking about. As the photo denotes, the useable length on the pin is 3.56 inches. You might want to measure the pin you are currently using and if you find the # C16902 is a good replacement for you. These pins also measure 1/2 inch diameter.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Replacement Rail Pins and Clips for Curt 5th Wheel Trailer Hitches and Gooseneck Adapters - Qty 4
- Accessories and Parts
- Fifth Wheel Hitch
- Pins and Clips
- CURT
more information >
Continue Researching
- Article: Basics of Tie-Down Chains and Binders
- Q&A: Fifth Wheel Rail Kit Recommendation 2016 Chevy Silverado 1500 for Pullrite Superglide 2700
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: How Many Bars Are Included with the Ra-28 Ladder Rack?
- Q&A: B&W Patriot Pins are Too Short to Fit Reese Adapter RP30154 for Ram 2500 Factory Pucks
- Q&A: Troubleshooting the Voyager WiSight Wireless RV Backup Camera System
- Q&A: Pin and Clip Needed to Install B&W Patriot in 2015 Ford F-250 Super Duty
- Q&A: Will PullRite Model 2700 SuperGlide Work with Curt Custom Base Rails on 2017 Chevy Silverado
- Q&A: ISR Bed Rails For 2700 Series Superglide On 2017 Short Bed Chevrolet Silverado 1500
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Rust Prevention
- Article: Ram Trailer Tow Prep Package
- Article: Flat Towing Package for 2010-2011 Jeep Liberty
- Article: Sidewinder with Rotating Turret for Short Bed Pickups